Use and Care Manual

ManualsBrandsPIONEERING TECHNOLOGY ManualsElectricalSmart Range-3 Prong

SMARTRANGE

F IRE P R E VENT I O N P R O DUC T S

INSTALLATION MANUAL

Pioneering Technology Corp.

2400 Skymark Ave., Unit 7

Mississauga, Ontario, CANADA L4W 5K5

1.800.433.6026

support@pioneeringtech.com

pioneeringtech.com

SUMMARY CONTACT

SmartRange helps prevent cooking res

before they can happen. Automatically

shuts off when a cooking re risk is

detected. Compatible with all electric

ranges.

Summary of content (4 pages)

PAGE 1
SMARTRANGE F I R E P R E V E N T I O N P R O D U C T S INSTALLATION MANUAL SUMMARY CONTACT SmartRange helps prevent cooking fires 1.800.433.6026 Pioneering Technology Corp. before they can happen. Automatically support@pioneeringtech.com 2400 Skymark Ave., Unit 7 shuts off when a cooking fire risk is pioneeringtech.com Mississauga, Ontario, CANADA L4W 5K5 detected. Compatible with all electric ranges.
PAGE 2
/4 COMPATIBILITY All electric ranges including glass top, coil and induction. For installations that: 1. Prevent the Heat Sensor from being installed directly to the underside of the rangehood or an over-the-range microwave, or allow for less than 18” of clearance between the range and the rangehood: Please contact your Pioneering Technology representative for custom installation assistance. • For indoor use only • Not suitable for use in professional kitchens.
PAGE 3
/4 3. The Heat Sensor and the Control Unit are factory paired. If the distance from the top of the range to the Heat Sensor is greater than 24” but less than 36”, please refer to the SmartRange User Guide for adjustments to the Heat Sensor’s sensitivity level. 4. If the distance from the top of the range to the Heat Sensor is greater than 36” please contact your Pioneering Technology representative for custom installation assistance.
PAGE 4
TROUBLESHOOTING 1. Issue: The Heat Sensor does not respond (green light should illuminate) when pressing the cover. Resolution: Check that the red battery disconnection tab has been removed. 2. Issue: The test alarm does not reset. Resolution: First, try another test alarm and wait for five seconds before resetting. If the test alarm still does not reset, the Heat Sensor and the Control Unit pairing must be carried out again. (See Chapter 3.