Manual
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and. if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmfut interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
[FOR USE IN THE UNITED KINGDOM]
INFRINGEMENT OF COPYRIGHT
Recording and playback of copyrighted material may require consent. See Copyright Act 1956 and the Performers' Protection Acts 1958 and
1972.
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.
MAINTENANCE
Capstan
Pinch roller
Erase head
Rec/play head
Pinch roller
CLEANING THE HEADS, PINCH ROLLERS AND
CAPSTANS
The heads, pinch rollers and capstans are likely to get dirty quite
easily. If these parts, particularly the heads, get dirty, the high fre-
quency components of e recording will not be reproduced and the
stereo balance will be impaired, resulting in a deterioration of the
playback sound. It is therefore recommended that the head section
be cleaned regularly.
1. Set the STANDBY/ON switch to STANDBY.
2. Press the eject button to open the cassette door.
3. Dip a cleaning swab in cleaning fluid and use it to wipe the heads,
capstans and pinch rollers.
NOTE:
After cleaning the head section, do not load a tape until the cleaning
fluid has dried eomplete/y (about two or three minutes).
I DEMAGNETIZING THE HEADS ]
After using the cassette deck for a period of time, the heads will
become magnetized. The same effect will occur if a magnetized
screwdriver, magnet or other magnetized object is brought too
close to the heads, When the heads become magnetized,
highfrequency sounds will be lost during recording or playback, and
interference noise may also occur. The heads should be regulady de-
magnetized with a head demagnetizer, which can be purchased at
most audio stores.
When demagnetizing the heads, make sure that the STANDBY/ON
switch of the cassette deck is set to ON. However, be sure to turn
down the amplifier's volume control to its lower position, and
disconnect any headphones from their headphones jack. For detailed
instructions, refer to the operating instructions of the head demagne-
tizer.
CLEANING THE FRONT PANEL I
Clean the deck regutarly with a soft cloth. If the front panel becomes
soiled, moisten a soft cloth with a weak solution of neutral detergent
(diluted in five to six parts water),wring the cloth well, and wipe the
panel clean. Never use volatile cleaners like thinners, benzine or alco-
hol because they will demege the panel finish.
3
<RRB1176>
En