Installation Guide

ManualsBrandsPioneer Industries ManualsBathVellano Polished Chrome 1-Handle Single Hole/4-in Centerset WaterSense Bathroom Sink Faucet (Drain Included)

Installation Guide

Single Handle Lavatory Faucet:

3VL161 • 3MT166 • 3MT178•

3VL160 • 3MT168 • 3MT180•

3VL161G • 3MT170 • 3MT181•

3MT160H • 3MT171 • 3MT181G•

3MT161 • 3MT171G • 3MT160•

3MT161G • 3MT176•

This product meets the following standards:

ASME A112.18.1 •

ANSI A117.1 •

ANSI / NSF 61, SECTION 9 •

CUPC / IAPMO LISTED / ADA COMPLIANT•

CONTAINS NO MORE THAN 0.25% WEIGHTED •

AVERAGE LEAD CONTENT

REV-10 31, 12

Engineering Excellence

Engineering E xcellence

Summary of content (9 pages)

PAGE 1
Engineering Excellence Engineering E xcellence Installation Guide Single Handle Lavatory Faucet: • • • • • • 3VL161 3VL160 3VL161G 3MT160H 3MT161 3MT161G • • • • • • 3MT166 3MT168 3MT170 3MT171 3MT171G 3MT176 • • • • • 3MT178 3MT180 3MT181 3MT181G 3MT160 This product meets the following standards: • • • • • ASME A112.18.1 ANSI A117.1 ANSI / NSF 61, SECTION 9 CUPC / IAPMO LISTED / ADA COMPLIANT CONTAINS NO MORE THAN 0.25% WEIGHTED AVERAGE LEAD CONTENT Pioneer Industries, Inc.
PAGE 2
Thank you for purchasing this Pioneer quality product. Tools Required Adjustable Wrench Teflon Tape Rags 3/32” Allen Wrench Prior to Installation • Observe all local plumbing and building codes before you begin installation. • Carefully shut off both hot and cold water supplies. • Plug the sink drain with a soft cloth to prevent intrusion of debris or the loss of any parts. • Pioneer reserves the right to make changes in the design of faucets without notice.
PAGE 3
Faucet Installation • • • • • • Note:- The faucet escutcheon (B) is supplied with rubber gasket (C) to form watertight seal. Do not use rubber gasket (C) and plumbers putty both to form watertight seal. For single hole installation - lead the escutcheon (B) & rubber gasket (C) from underneath of the faucet, lead the SST hose connectors (A) through faucet mounting hole.
PAGE 4
Pop-up Drain Installation 1. 2. 3. 4. 5. 6. 7. 8. Remove the pop-up stopper (I) and pop-up flange (J) from the pop-up assembly. Apply adequate amount of plumbers putty underside of pop-up flange(J). Then insert pop-up drain assembly from underside of the sink and secure the pop-up flange (J) from the top. Rotate the drain body so that horizontal rod hole faces back of the faucet. Hold the pop-up assembly in place and tighten the locknut (K). Remove the excess putty. Connect the trap (L).
PAGE 5
Pop-up Drain Installation 5 REV-10 31, 12
PAGE 6
Grid Drain Installation 1. 2. 3. 4. 5. Remove the grid trim ring (S) from the grid drain assembly (T). Apply adequate amount of plumbers putty underside of the grid trim ring (S). Insert the grid drain assembly (T) from under the lavatory sink. Attache the grid trim ring (S) from top of the drain hole. Hold the grid trim ring (S) in place while threading the locknut (U) untill the locknut is snug with the underside of lavatory sink. Tighten the locknut (U). Remove the excess putty. Connect the trap (L).
PAGE 7
Main Supply Connection • • • • • • Use main supply hoses (V) to connect SST hose connectors to the main supply stops (W). Tighten with adjustable wrench. Do not overtighten. Conventionally left is hot and right is cold. Turn on water. Check of any leaks. Make sure all the connection are secure. Remove the aerator (X). Make sure the pop-up drain is open. Turn on the handle. Flush and allow water to run at full flow for at least one minute. Turn off water. Replace aerator (X).
PAGE 8
To Set or Adjust Temperature Limit Stop Caution: Valve is preset at the factory test at maximum. Adjust as necessary. Please see the instructions below: • • • • • • Turn off water and relieve the pressure. Remove handle (A1) by removing set screw hole cover(Y) and loosening set screw(Z), lift off the handle. Unscrew retainer sleeve (B1) and retainer Nut (C1) counterclockwise. Use two fingers raise the red adjustment ring (D1).
PAGE 9
Engineering Excellence Engineering E xcellence 3325 S. Garfield Ave. | Commerce, CA 90040 Telephone: (800) 338-9468 | (323) 888-8873 | Fax: (323) 888-9515 Hours: M - F, 7:30am to 5:00pm PST www.pioneerind.