Operating Instruction

Use a screwdriver to remove the battery cover of the remote control, insert

two AAA 1.5V dry batteries in correct polarity. Close the battery cover and

ﬁx it with the screw. (Battery replacement also according to the above

steps)

Introduction

This controller is used for electric kid’s cars, including a remote control

and a controller (for receiving).It uses 2.4G wireless remote control. The

controller controls two motors to rotate. The remote control uses 3V

battery to supply power. The receiver uses 12V battery to supply power.

Product ship with no battery.

1.All batteries should be inserted in the correct polarity.

2.Non-rechargeable battery cannot be recharged

3.Take out and properly deal with the dead battery. To avoid injury, please

keep kids away from the battery.

4.The direct contact between the positive and negative terminals may result

in ﬁre or explosion. Avoid direct connect between the terminals.

5.Do not mix old and new batteries. DO not mix alkaline, standard(carbon-

zinc),or rechargeable(nickel-cadmium) batteries.

6.Only an adult who has read and understood the safety warnings can

recharge the battery.

+ -

PAGE 1
Introduction This controller is used for electric kid’s cars, including a remote control and a controller (for receiving).It uses 2.4G wireless remote control. The controller controls two motors to rotate. The remote control uses 3V battery to supply power. The receiver uses 12V battery to supply power. Product ship with no battery. - + + 1 - Use a screwdriver to remove the battery cover of the remote control, insert two AAA 1.5V dry batteries in correct polarity.
PAGE 2
Instructions: Connect the controller to the electric kid’s car with wire and turn on the car and controller at the same time. Coding the controller and receiver when control with the remote controller. When the remote controller ﬁrst turns on, the top light ﬂashes slowly and then turns on the receiver. When the light long bright, it means coding ﬁnishes and you can turn on the car. There are 6 buttons on the remote controller:forward, backward, left, right, Speed Conversion , stop.
PAGE 3
Press ▼ reverse button, the car goes reverse. Press the stop button to brake the car urgently. Press stop button again to release the brake system. Press the turn left button, car turn left, Press the turn right button, car turn right, The S button is speed button, one light on is low speed, two lights on for intermediate speed, three lights on for high speed. Battery Warnings The batteries are not included.