User manual PineBuds Pro 1.
. How to wear LED Insert each earbuds into your ear and ensure the microphones are pointed towards your mouth. The earbud LED light are facing up. Microphone 2.1 Changing Eartips For the optimal audio and ANC experience, it is recommended to try each of the different eartips sizes. The fit should feel light and comfortable in your ear. The medium eartips are pre-mounted on the earbuds.
. How to charge Get up to 5 hours on a single charge with ANC. Total charge of up to 20 hours with the charging case. 3.1 Charging the earbuds Place the earbuds in the charging case and close the lid. It takes up to 1.5 hours to fully recharge the earbuds. When the charging case is opened, the LEDs on the earbuds will light up red. LED light dims when battery is fully charged. 3.2 Low Power Shut Off When the battery voltage is below 3.2V, the earbuds will turn off. 3.
. What the LEDs mean Earbuds Status OFF (Red LED flashes 1 time and then off). ON (Blue LED flashes every 1 second). Factory reset success (Purple LED blinks) Charging RED LED lights up. Full Charged RED LED Dims. Pairing mode: Left earbud Blue LED flashes Pairing Success: Left earbud Blue LED goes dark Charging case has 4 White LEDs flashing indicating charging activity. When charging reaches 100%, all 4 LEDs lit up and stop flashing.
. How to pair 5.1 Left/ Right mutually connects Remove earbuds from case, go to your Smartphone settings and enable Bluetooth pairing. Look for “PineBuds Pro” and establish the pairing process. a. During peer pairing mode, Left earbud LED alternates in Red + Blue color. Right earbud LED blinks Blue color every 5 seconds. b. When Peer-pairing is successful, BOTH earbuds LED blinks Blue every 5 seconds. 5.2 Peer - Connected Power on the earbuds by removing them from the charging case.
. How to use 6.1 Powering the Earbuds ON/ OFF To turn ON the earbuds, remove from the charging case. If not inside the charging case, press buttons for 5 seconds. > Blue LED flash 1 sec. > Power ON. To turn OFF earbuds, place inside the charging case. If not putting inside the charging case, press button for 5 seconds. > Red LED flash 1 sec. > Power OFF. 6.
continue How to use 6.3 Call controls Left earbud Function Right earbud Tap left or right twice Answer call Tap left or right twice Press left or right for 1 second End/Reject call Press left or right for 1 second Press left or right for 2 second Mute/unmute microphone Press left or right for 2 second Tap left or right button twice Hang-up call Tap left or right button twice 6.4 Advanced ANC Regular ANC Mode: Offers 25dB of Noise reduction. Super ANC Mode: Offers 45dB of Noise reduction.
continue How to use 6.5 HearThrough HearThrough lets you pay attention to your surroundings when engage in conversation, or not on a call, without needing to remove the earbuds. The microphones pick up surrounding sounds and transmit them to the speakers. 6.6 Mono earbud use Either earbud can be used individually for mono music playback or for calls. When used as a mono earbud, the earbud retains its current button functionality.
FCC Caution: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and ( 2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.