Instructions / Assembly

Assembly Instruction for
END TABLE
CTMS100ET/CTMS100ETE
No
C
No
1. We recommend that you should assemble this product with the assistance of another person; this
will make assembly easier, and will help to eliminate damage the product or injury to persons
during assembly.
3. Please do not over tighten screws or bolts .
4. Please put all parts on a non - abrasive floor before assembly, and follow the assembly steps to
assemble your newly purchased product correctly and efficiently.
Caution: Please read instructions thoroughly before unpacking assembly parts. Sharp, exposed staple
tips can cause injury, therefore, for your protection, please remove any exposed staples used in packing.
2. Be sure to check all packing materials carefully for small parts that may have come loose inside
the carton during shipment.
MADE IN VIETNAM
PAGE 1 OF 2
STEP 1
STEP 2
1
4
4
2
5