3839 OnWave User Guide 1/18/05 12:47 PM Page 2 direct digital synthesis FM user guide P E 560T transmitter P E 500R receiver P E 506R receiver specs available on-line at www.phonicear.
3839 OnWave User Guide 1/18/05 12:47 PM Page 3 FCC and Industry Canada Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
839 OnWave User Guide 1/18/05 12:47 PM Page 4 table of contents Transmitter: PE 560T . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Wide-band Receiver: PE 500R. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Narrow-band Receiver: PE 506R . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Ground Plane . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Large Area Antenna. . . . . . . . . . . . . . . . . . . . . . . . . . . .
3839 OnWave User Guide 1/18/05 12:48 PM Page 5 transmitter: PE 560T 1 digital display 2 level + Increases output levels when the volume of the sound source cannot be adequately adjusted 3 Lights if antenna is connected incorrectly or if antenna is being detuned by other electrical equipment 11 overload indicator Lights if input exceeds maximum level for transmitter. If this lights, reduce input level to transmitter.
3839 OnWave User Guide 1/18/05 12:48 PM Page 6 transmitter: PE 560T (cont’d) front 1 2 4 6 8 10 3 5 7 9 11 back 12 13 14 15 2
3839 OnWave User Guide 1/18/05 12:48 PM Page 7 wide-band receiver: PE 500R front 22 volume/power 23 24 23 charge socket 1.3mm power jack. Connects to PE 500C and AT0749 charger to recharge NiCad batteries (Never recharge Alkaline batteries!) 25 22 24 accessory socket Connect listening accessories such as teleloops, earbuds, and headsets. 3.5mm; stereo headset compatible.
3839 OnWave User Guide 1/18/05 12:48 PM Page 8 narrow-band receiver: PE 506R 28 front accessory/charge socket 3.5mm jack. Connect listening accessories such as teleloops, earbuds, and headsets. Also connects to PE 300C and AT0534 charger to recharge NiCad batteries (Never recharge Alkaline batteries!) 29 charge light 30 channel selector 28 29 22 Choose one of six different channels.
3839 OnWave User Guide ground plane 1/18/05 12:48 PM Page 9 (note that connectors have left-handed thread) 16 antenna jack Attach antenna here 17 cable jack Attach cable here 18 mounting holes 16 17 Use screws to mount on a wall or, preferably, a ceiling; may also be placed on a tabletop 18 5 18
3839 OnWave User Guide 1/18/05 12:48 PM Page 10 large area antenna 19 tuning ring Do not deform or move this ring, or you may affect the antenna's tuning and efficiency 20 worm clamps 20 Loosen both clamps; extend the large center section to the black ring; tighten lower clamp; extend the smaller element to the black ring; tighten the top clamp 21 mounting hole/set screw Use to mount on a tripod with a mast. Ground your mounting pole, tripod, or other holder to a metal surface.
3839 OnWave User Guide 1/18/05 12:48 PM Page 11 OnWave system setup and operation 1 understanding hearing assistance without the OnWave system ? h! ug co but with the OnWave system h! ug direct-mount a standard antenna • distance • noise • echo 10 0 30 m 0f t co 2a • distance • noise • echo Attach antenna to back 1 of transmitter AT0777 PE 560T 2 Check RF Fault indicator. 1 th en If lit, adjust antenna connection or remote mount antenna.
3839 OnWave User Guide 1/18/05 12:48 PM Page 12 OnWave system setup and operation (cont’d) 10 0 30 m 0f t 2b remote-mount a standard antenna optimizes transmitter/antenna position PE 560T AT0775 ground plane with cable (AT0776) or ground plane with connector kit (AT0775) AT0776 then PE 560T or ft 00 30 0m remote-mount a large-area antenna 10 2c optimizes transmitter/antenna position PE 560T-LA AT0773 Channels A– E, 1–20 or AT0774 Channels F – J, 21– 40 then >2m/6ft PE 560T NOTE: ! Groun
3839 OnWave User Guide 1/18/05 12:48 PM Page 13 OnWave system setup and operation (cont’d) 3 mount the transmitter in rack (requires remote mounting antenna) or place on top of rack AT0757 AT0780/ AT0781 2 Plug transformer into 1 OnWave power input Plug transformer into 2 wall socket or 1 4a connect line input 70Vrms 10Vrms 2Vrms GND 1 Select Line-in If overload indicator speaker terminal block or or then 2 lights when connecting .
3839 OnWave User Guide 1/18/05 12:48 PM Page 14 OnWave system setup and operation (cont’d) 4b connect microphone input 1 Plug in microphone PE 560T 1 XLR input 2mVrms then 2 Select Mic-in 2 4c activate phantom power (for electret condenser mics only † ) 1 Press function 2 Press line/mic 1 2 Repeat steps to deactivate phantom power †Use phantom power only with condenser microphones.
3839 OnWave User Guide 1/18/05 12:48 PM Page 15 OnWave system setup and operation (cont’d) 5a adjust output levels (if your house system has adjustable volume) house system on and play 1 Turn test signal 1 2 sound system 2 Increase volume until... 4 3 ...overload indicator lights decrease sound 4 Slowly system volume until... ...
3839 OnWave User Guide 1/18/05 12:48 PM Page 16 OnWave system setup and operation (cont’d) 6 music or speech? (set for typical signal content) or 7 set bass cut (optimize for listeners or to reduce low-freq noise) Recommended Standard Setting Speech: 160Hz Music: 40Hz Recommended Noise Reduction Setting (air conditioning, low frequency hum) Speech: 160Hz Music: 160Hz 20 10 0 speech 160 H z 40 Hz 320 H z -30 80 Hz -20 music -10 -40 -50 -60 101 102 103 104 transmitted frequency respons
3839 OnWave User Guide 1/18/05 12:48 PM Page 17 OnWave system setup and operation (cont’d) 8a set transmitter band & channel (optional; must tune your receiver to match!) 1 Press function 1 channel to select 2 Press wide-band for 500R (channels indicated by letters) or narrow-band for 506R (channels indicated by numbers) 2 then 3 Press channel to select channel within your chosen band For narrow-band channel and frequency information see 506R receiver diagram on other side.
3839 OnWave User Guide 1/18/05 12:48 PM Page 18 OnWave system setup and operation (cont’d) 8c set PE 506R channel (must match your transmitter!) channel that 1 Find matches transmitter Phonic Ear PE 506R Narrow-Band Receiver 99 014737 frequency – + 1 C H A N N E L N O 7 8 9 10 11 12 1 5 11 14 17 19 F R E Q C O D E – 72 MHz + Set channel 2 (Users can switch to then Phonic Ear PE 506R Narrow-Band Receiver 99 014737 2 9 different channels if you have set up multiple transmitters each w
3839 OnWave User Guide 1/18/05 12:48 PM Page 19 OnWave system setup and operation (cont’d) 10 lock/unlock your settings 1 Press function 1 2 Press level - to lock 2 or 3 Press function 3 4 Press level + to unlock 4 11 save settings saves settings in temporary memory 1 1 Press power to turn unit off and save settings or saves settings permanently if unplugging unit or power outage occurs 1 1 Press function 2 Press power 2 15
3839 OnWave User Guide 1/18/05 12:48 PM Page 20 OnWave system setup and operation (cont’d) 12 receiver batteries 1 Light flashes when batteries are low 2 hours of battery life remain (4 hours with alkaline battery) 1 warning! Place charger case on its side when connecting to charger cord. Do not stand charger case on bottom when charging. Damage to charger may occur.
3839 OnWave User Guide 1/18/05 12:48 PM Page 21 OnWave system setup and operation (cont’d) 13 how to use the body-worn receiver AT0489 wire clip or AT0737 pouch or AT0076 lavalier cord then then 1 On/Volume (verify power light is on) 1 17 2 2 Switch to channel/ program (PE 506R only)
3839 OnWave User Guide 1/18/05 12:48 PM Page 22 warranty time period of warranty This warranty will go into effect upon the date of purchase and will stay in effect as long as the instrument remains the property of the original owner. ONWAVE™ has a 3-year warranty; VOCALIGHT™ has a 2 year warranty. All other products have a 1 year warranty. what to do if you need service If you require service under the warranty terms, obtain a service order form either online at www.phonicear. com/support.
3839 OnWave User Guide 1/18/05 12:48 PM Page 23 troubleshooting no sound • If using the 500R, verify the receiver is tuned correctly (see user instructions section 8b ) • If using the 506R, verify the channel selected on the receiver matches the channel selected on the transmitter (see user instructions section 8c ) • If using 500R, check if the receiver power indicator light is on; if unlit, or flashing, replace or recharge receiver batteries.
3839 OnWave User Guide 1/18/05 12:47 PM Page 1 us: 800.227.0735, then press 5 • canada: 800.263.8700 outside u.s./canada: Call your local Phonic Ear dealer • website: www.phonicear.com © 2003 Phonic Ear Inc. Phonic Ear and the names of Phonic Ear products are trademarks or registered trademarks of Phonic Ear Inc. in the U.S. and other countries. 821-7289-102/rev.