HellowayTM PTE-CP70 800/1900MHz Signal Booster User Manual 1/8
FCC WARNING Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PACKAGE CONTENTS sddg 1 2 1. 1x PTE-CP70 Booster with N Female connectors. 2. AC Power Adaptor. 3. Screws Mounting Kits. 4.
INSTALLATION PROCEDURES NOTE: This wireless amplifier can be used for home, office, apartment and all other applicable area. Do not place the equipment in direct sunlight or in an area that has abrupt temperature and humidity changes. The whole Kit includes everything you need to enhance coverage within your area. Installation of the Repeater is very easy and takes minutes. Just mount the outdoor antenna and connect to the booster input connector.
power cord to a grounded alternating current (AC) outlet. Also, if the Power Cord is connected to a power strip, make sure that the power strip is switched on. 3) The LED light is green, indicating that the Amplifier is ready to use. NOTE: To prevent damage to the Amplifier, before plugging in the Amplifier to a DC/AC power outlet, make sure that all of the connections (ANTENA to AMPLIFIER) to the Amplifier are tight and secure. WARNING: The input voltage for the Amplifier is 6V~24V DC.
(Optional) 1. Mounting the Amplifier with Velcro: You can leave the Amplifier on top of a flat surface or use the enclosed Velcro straps to mount the Amplifier. There are two Velcro strips (hook-and-loop pairs) in the box for mounting the amplifier. Determine the location where your Amplifier will be placed. Clean the intended surface and allow it to dry. Peel the protective paper from the back of the hook sides of the Velcro.
STARTING THE AMPLFIER The signal is received by the outside antenna from the cell tower, then amplified and transmitted to your phone through the inside antenna. When the phone transmits, the signal is received by the inside antenna, then amplified and transmitted to the cell tower through the outside antenna. Now you are ready to make and receive cell phone calls with powerful signal amplification! Note that it is normal for the Amplifier’s case to be warm during operation.
WARRANTY Warranty information applicable to your Amplifier Warranty Period: 2 year. Type of Warranty Service: Customer Replaceable Unit and Customer Carry-In or Mail-In Service. Phonetone Company is not responsible for Shipping Cost. For Warranty service consult the telephone list at www.phonetone-tech.com/contact us.