Datasheet
https://www.phoenixcontact.com/gb/products/2891390
04/12/2017Page1/4
Industrial Ethernet Switch-FL SWITCH SFNT 5GT-2891390
Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's
documentation. Our General Terms of Use for Downloads are valid
(http://phoenixcontact.com/download)
Wide-temperature Ethernet switch, five TP RJ45 ports, automatic detection of data transmission speed of
10/100/1000 Mbps (RJ45), autocrossing function, reads QoS priority messages, accepts security frames.
Product Description
The FL SWITCH SFN 5GT supports the auto negotiation function at the twisted-pair ports and offers transmission speeds of 10/100/1000Mbps.
Mixed operation for the connection of segments with different data transmission speeds is also supported.
Switching properties
-Multi-address function
The switch can store up to 8192 MAC addresses in its address table.
-Quality of service
In case of heavy traffic, packets tagged with higher priority 802.1Q or Differentiated Services values will be given preference. The switch has four
internal priority queues.
-Multicast filtering
The multicast filter will block PROFINET PTCP-Delay traffic. This is accomplished by filtering frames with the destination MAC address in the range
01-80-C2-00-00-02 through 01-80-C2-00-00-0F. Note that the filter blocks LLDP traffic because PTCP-Delay uses the same MAC address, 01-80-
C2-00-00-0E.
-Alarm contact
The switch provides contacts (R1, R2) for remote alarms if a failure is detected. Alarms are triggered if one or both power supplies fail. An alarm
can be triggered if a port link is lost. Individual port alarms can be enabled via a DIP switch located on the bottom of the switch. The alarm relay is a
normally closed type. When there are no faults, the contact is held open. When a fault occurs, the relay is de-energized to close the contact.
-Link monitor DIP switch
To enable an alarm for a port, move the appropriate slider to the ON position. To disable an alarm, move the appropriate slider to the OFF
position.
Power connection is via a removable COMBICON connector. US1 and US2 are 24 V DC and GND is 0 V DC. FE, functional earth.
Why buy this product
All ports offer transmission speeds of 1000 Mbps
Jumbo frame support (frame size up to 10,240 bytes/frame)
QoS-prioritized (Quality of Service) messages
The switch also offers cable locking and port blocking
Alarm contact for power supply and link status diagnostics
Wide operating temperature range (-40°C ... +75°C)
Key Commercial Data