User Manual Dagger-QG User Manua Dagger QG and Dagger QG Slim 4-8470-10 Tracking Device The information presented in this document is strictly confidential and contains trade secrets and other confidential information that are the exclusive property of Phillips Connect Technologies.
User Manual Contents 1 Introduction 3 2 Hardware Design 4 2.1 Basic Hardware 4 2.2 Basic RF Performance 5 2.3 Certification and Safety 6 Test Items 7 3.1 Hardware 7 3.
User Manual 1 Introduction The Dagger-QG is a self-contained tracking device that combines the GPS with LTE and BLE connectivity. The Dagger-QG is a single endpoint device to a user or a server application. It can be quired, updated and configured either through a serial connection, or an over the air LTE IPnetwork. The Dagger-QG presents itself over these connections as an enhanced cellular modem with attached functional elements.
User Manual 2 Hardware Design 2.1 Basic Hardware Items Requirement Baseband Chipset Qualcomm Cat.M1 Qualcomm SDR Internal Support for LTE Cat.M1 4G band support : Band 2/4/5/12/13/25/26 BLE5.0 band support : ISM 2.4GHz Internal Antenna / Chip Antenna Dedicated high performance ceramic antenna UART TX UART RX 12V DC Input（1A current） GPI GPO GND Supported Supported Supported 2 LEDs (Red and Green) Built in battery（8.
User Manual UART A UART port is provided for AT command and data interaction and optionally for application specific control. Battery Monitor The battery monitor is internal analog input scaled such that the DC value of the power input pin to the Dagger-QG system is measured. Watchdog Qualcomm chipset supports internal software and hardware Watchdog. Motion Detect This function will work with firmware power down options to keep the Dagger-QG in a very low power down state until motion is detected.
User Manual 3 Test Items 3.1 Hardware Test Item Description Function Test • • • • • • • • Power Input Test Heat Dissipation Test UART Stability Test GPIO Level Test LED Stability Test Drop Down Test ESD Test High/Low Temperature Test RF Test • • • • LTE Conformance Test GPS Performance Test BLE Performance Test Antenna Performance Test 3.2 Software Test Environment Construct ➢ UART Test environment 1. Connect Dagger-QG to pc with console board. 2. Open Terminal tool and send the AT command. 3.
User Manual Mechanical Structure (115*16*92 mm) TOP SIDE BOTTOM FRONT © 2022 Phillips Connect Technologies LLC 7 / 9
User Manual Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
User Manual Industry Canada statement This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licenseexempt RSS(s).
