User Manual Arrow-QG Arrow-VI 4-6340-17-12V 4-6340-10 4-6341-17 4-6341-10 Vehicle Tracking Device The information presented in this document is strictly confidential and contains trade secrets and other confidential information that are the exclusive property of Phillips Connect Technologies.
User Manual Contents 1. Introduction 2. Design 3.
User Manual 1 Introduction The Arrow-QG (Arrow-VI) is a self-Contained vehicle tracking device that combines GPS location with LTE and BLE connectivity. The Arrow-QG (Arrow-VI) appears to a user or a server application as a single endpoint device. It can be queried, updated and configured either through a serial connection, or an over the air LTE IP connection. The Arrow-QG (Arrow-VI) presents itself over these connections as an enhanced cellular modem with attached functional elements.
User Manual 2 Design 2.1 Basic Hardware Items Baseband Chipset RF Transceiver Memory Air Interface Frequency Requirement Qualcomm Cat.M1 Qualcomm SDR Internal Support for LTE Cat.M1 4G band support : Band2/4/5/12/13/25/26 BLE5.0 : 2.
User Manual UART A UART port is provided for AT command and data interaction and optionally for application specific control. Relay Driver A 500mA sink capable output pin is provided. This pin is meant to drive a relay coil intended to interrupt the starter solenoid relay for the ignition circuit to a car. Voltage Monitor The battery monitor is internal analog input scaled such that the DC value of the power input pin to the Arrow-QG (Arrow-VI) system is measured.
User Manual 2.3 Certification and Safety Items Drop Design Temperature Range Humidity: Altitude: FCC Certification IC Certification ESD Requirement © 2021 Phillips Connect Technologies LLC Requirement 0.
User Manual 3 Testing Test Item Baseband Function Test RF Test Description • Power Input Test • Power Consumption and Current Test • Heat Dissipation Test • UART Stability Test • GPIO Level Test • Drop Down Test • ESD Test • High/Low Temperature Test • LTE Performance Test • GPS Performance Test • BLE Performance Test • Antenna Performance Test © 2021 Phillips Connect Technologies LLC 7 / 10
User Manual Mechanical Structure(mm) © 2021 Phillips Connect Technologies LLC 8 / 10
User Manual Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
User Manual Industry Canada statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
