Hardware Installation Guide AdvantageGPS.
Welcome Experience 4G LTE Evo, the next evolution in GPS tracking. Advantage by Procon Analytics - where automotive telematics meets genuine analytics. Installation Made Easy Tools needed for install: screwdrivers, wire strippers and cutters, crimping tool and voltmeter. Plus, you might want to have the following handy: connectors, velcro, and zip ties. • Make sure there is not metal above the device as it may interfere with the signal.
Evo Wiring [POWER/SERIAL CABLE DIAGRAM] We’ve included a detachable wiring harness. Connect everything before plugging harness into the Evo device. Black Wire: Ground – Connect the ground wire to the vehicle chassis (should always be first connection made.) Red Wire: 12 VDC Constant Power – Connect to a constant power source. Voltage should read 12V when the vehicle’s ignition line is in the off position.
ECM Starter Disable [DIAGRAM 1] If the starter is controlled by the ECM (Engine Control Module), splice the wire that leads directly from the ECM to the starter. Note: Do not splice into the wire leading from ignition switch to the ECM. GREEN (Not In Use) RED = Ignition WHITE = Starter YELLOW = Input Note: Yellow wire connects to Yellow relay wire.
Starter Interrupter [OPTIONAL FEATURE – DIAGRAM 1] • Locate and cut the starter wire of the vehicle. This wire will only display 12VDC while the vehicle is starting. • Connect yellow wire from the harness to the yellow wire of the starter interrupt relay. • Connect red wire from the starter interrupt relay to the ignition switch side of the starter wire. • Connect white wire of the starter interrupt relay to the starter side of the starter wire.
Payment Reminder [OPTIONAL FEATURE] • Locate a switch ignition power wire that reads 12V when the vehicle’s ignition is in the ON position and 0 Volts when the vehicle ignition is in the OFF position. The ignition wire retains 12V as the vehicle is starting. • Connect the white wire from harness to the vehicles ignition wire. • If the white wire is not connected, the payment reminder feature will activate upon the change of vehicle voltage, instead of when the vehicle starts.
LED Troubleshooting [TECHNICAL DATA] Technical Data Operating Voltage 7V - 28V Power Consumption 2.5 mA (standby), 50 mA (active) Operating Temperature -30oC to +75oC Storage Temperature -40oC to +85oC Operation Humidity 20% to 90% (non-condensing) Solid Green = Cellular Signal is OK Flashing Green = Searching Solid Red = GPS Signal is OK Flashing Flashing Red = Searching Note: The following LED behavior is indicative of an over-the-air update: • Solid Red (15 secs.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
If you have questions or would like to have our team of experts help you with your install, please: 1-800-553-7031 Support@AdvantageGPS.com AdvantageGPS.com/Knowledge-Center AdvantageGPS.