User's Guide

ManualsBrandsPHILIPS ManualsElectronicsRemote Control

User guide for Remote Control RC4284505/01RP(K)

1. Know your Remote

All codes are RC6 mode 0 based (DEC)

000.004

000.005

000.006

000.007

000.008

000.009

000.217

000.000

000.191

Vol +

000.016

EXIT

000.159

CH+

000.032

Vol -

000.017

MUTE

000.013

CH-

000.033

000.001

000.002

000.003

Rewind

000.043

Play

000.044

FFwd

000.040

Stop

000.049

Pause

000.048

Record

000.055

RED

0.109

GREEN

0.110

YELLOW

0.111

BLUE

0.112

000.088

000.090

000.092

000.091

000.089

Back

000.010

Home

000.084

Guide

000.204

Power

000.012

Ambilight

000.143

Amazon

000.186

Google Play

000.137

NETFLIX

000.118

Youtube

000.121

Info

000.015

Voice

(BLE key)

Source

000.056

Summary of content (3 pages)

PAGE 1
User guide for Remote Control RC4284505/01RP(K) 1. Know your Remote All codes are RC6 mode 0 based (DEC) Power 000.012 Ambilight 000.143 Amazon 000.186 Google Play 000.137 NETFLIX 000.118 Youtube 000.121 Info 000.015 Voice (BLE key) Source 000.056 ^ 000.088 < 000.090 OK 000.092 > 000.091 v 000.089 Back 000.010 Home 000.084 Guide 000.204 Rewind 000.043 Play 000.044 FFwd 000.040 Stop 000.049 Pause 000.048 Record 000.055 RED 0.109 GREEN 0.110 YELLOW 0.111 BLUE 0.112 Vol + 000.
PAGE 2
. How to pair your RCU with TV Step 1: input 2*AAA batteries to Battery compartment. Step 2: presses the Source key for 3 seconds. Step 3: After 3s, the blue LED blinks to acknowledge. The LED will blink when RCU in pairing mode. Step 4: When the user releases the key, RF pairing will start, the blue LED remains blinking. If pairing is successful, the blue LED will be turned off after successful pairing.
PAGE 3
FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Caution Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.