Wireless Communication Module 989803202921
Table of Contents ENGLISH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table of Contents ii
Wireless Communication Module ENGLISH Introduction This document explains how to use the features of the HeartStart Intrepid’s Wireless Communication Module. The Wireless Communication Module (hereafter “Communication Module”) allows the HeartStart Intrepid monitor/defibrillator to wirelessly transmit data such as 12-lead ECGs, vital signs data, and event summaries over cellular/mobile networks to Philips Emergency Care Informatics Suite.
Connecting the Communication Module 3 Push the SIM card into the slot until it is fully seated and latches. 4 Close the rubber plug on the SIM slot. Connecting the Communication Module Depending on your carry case, place the Communication Module in either the rear pouch or side pouch. Figure 1 shows the rear pouch installation. The side pouch installation is similar.
Connecting the Communication Module Figure 1 4 Connecting the Communication Module and the HeartStart Intrepid a. Unsnap the rear pouch from the HeartStart Intrepid, then insert the connector through the hole in the rear pouch. b. Plug the connector from the Communication Module into the device, and tighten the two thumb screws. c. Snap the rear pouch to the device. d. Place the module in the rear pouch. Turn on the HeartStart Intrepid. The green LED on the Communication Module is on.
Configuring Communication on the HeartStart Intrepid Configuring Communication on the HeartStart Intrepid The HeartStart Intrepid defaults to Wi-Fi Mode. To configure the Intrepid for cellular wireless communication, ensure that the device is first switched to Cellular Mode. To configure the HeartStart Intrepid for cellular wireless communication: 1 Press Smart Select knob, then from the Main Menu, choose .
Sending Data with the Communication Module Figure 3 Configuration - Communication screen Configuration - Communication Reference ID Intrepid SN: CNX000999 EMS ID: 0225 Cloud URL https://www.philips-emergencycare.
Sending Data with the Communication Module To send the current 12-lead data from 12-Lead Mode during an event: 1 In 12-Lead Mode, press thesoft key. When the 12-lead acquisition is complete, press the soft key. If the device has been configured with a destination list, the list is displayed. 2 Select the destination for the 12-lead report, then press the Smart Select knob. Data transmission begins when a destination is chosen.
Specifications Cleaning The Communication Module can be cleaned using the same cleaning instructions for your HeartStart Intrepid monitor/defibrillator listed in the Maintenance chapter of the HeartStart Intrepid Instructions for Use. Specifications Part Number: 989803202921 Wireless Communication Module Weight: 0.25 kg (0.55 lb) including cable Dimensions: 96 mm X 90 mm X 26 mm (3.8 in x 3.
Specifications Table 1 Effective Isotropic Radiated Power (Continued) Technology Bands Transmitter RF Power Levels Antenna Gain EIRP UMTS/ HSDPA/ HSUPA 850 MHz Power Class 3 (0.25 W, 24 dBm) -2.39 dBi 21 dBm UMTS/ HSDPA/ HSUPA 900 MHz Power Class 3 (0.25 W, 24dBm) -1.63 dBi 22 dBm UMTS/ HSDPA/ HSUPA 1900 MHz Power Class 3 (0.25 W, 24dBm) -2.35 dBi 21 dBm UMTS/ HSDPA/ HSUPA 2100 MHz Power Class 3 (0.25 W, 24 dBm) -2.
Specifications Industry Canada Statement This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
Philips Healthcare is part of Royal Philips On the web www.philips.com By e-mail healthcare@philips.com ©2019, 2020 Koninklijke Philips N.V. All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright holder. Philips and the Philips shield are trademarks of Koninklijke Philips N.V.