User's Manual

ManualsBrandsPhilips Medical Systems North America ManualsElectronics2.4G Radio Module

IITBV1 ITS Module User’s Manual

Manual

Philips Medizin Systeme Böblingen GmbH

Hewlett-Packard-Strasse 2, 71034 Böblingen, Germany, Tel +49(0)7031 463-0, Fax +49(0)7031 463-2202

Geschäftsführer: Dr. Dieter Haase (Sprecher), Dr. Peter Ziese, Matthijs de Groot

Registergericht Stuttgart Reg.-Nr. HRB 245187, Sitz der Gesellschaft: Böblingen, www.philips.com/healthcare

Product: IITBV1-ITS Module

Model: IITBV1

FCC ID: PQC-IITBV1

IC: 3549A-IITBV1

For OEM integration only – device cannot be sold to general public. Therefore, we will not

supply a User’s manual.

We will ask OEM to include the following Notices required by FCC/ IC on the product and in

the User’s manual.

Notifications

FCC ID: PQC-IITBV1

IC: 3549A-IITBV1

NOTICE

Federal Communication Interference Statement (United States only)

This equipment has been tested and found to comply with the limits for a class B digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Re-orient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

Summary of content (4 pages)

PAGE 1
IITBV1 ITS Module User’s Manual Manual Product: IITBV1-ITS Module Model: IITBV1 FCC ID: PQC-IITBV1 IC: 3549A-IITBV1 For OEM integration only – device cannot be sold to general public. Therefore, we will not supply a User’s manual. We will ask OEM to include the following Notices required by FCC/ IC on the product and in the User’s manual.
PAGE 2
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected • Consult the dealer or an experienced radio/TV technician for help This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Canadian Department of Communications Industry Canada Notice (Canada only) This Class B digital apparatus complies with Canadian ICES-003.
PAGE 3
radioélectriques (RF) CNR- 102 de l’IC. Cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le dispositif rayonnant et le corps (à l’exception des extrémités : mains, poignets, pieds et chevilles). Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
PAGE 4
WARNING: The FCC / The Industry Canada regulations provide that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Manual and Product Labeling information To The End User The end user manual shall include all required regulatory information/warning as show in this manual.