User's Manual

Date: December 23,2014
UL LLC.
333 Pfingsten
Road
Northbrook, IL 60062
PHILIPS
Philips
Lighting Electronics N.A.
10275
West Higgins Road
Rosemont, lL
60018
To whom
it
may concern:
In regard to our StarSense LCN7330P
(FCC
ID: VBO-LCN7330P
and IC ID:
I35Y-LCN7330P) Segment
Control
node, this component is not offered for sale by
itself, but only as
part
of the
LFC73l0 Segment Controller cabinet.
As such, there
is
no user/installation
manual for
this
individual component;
it is only included and described as a
part
of the
larger
assembly.
The
documents
provided
are the only documents that
describe this
product.
The statements below will be added to the
revision of the manual. These statements
will be in English language in
the
EN manual
and
French in
the
FR manual:
In regard
to the wording
for
the
20
cm separation
requirement, the following statement
will be added:
To comply with FCC/IC kF exposure limits
for
general population
/ uncontrolled exposure,
the antenna(s)
usedfor this transmitter must be installed to
provide
a separation distance ofat
least 20 cmfrom all
persons
and
must
not be co-located or operating in conjunctionwith
any other antenna or
transmitter.
In regard to the wording required by FCC
part
15.105 for a class A device the
following statement will be added:
This
equipment has
been tested andfound to comply
with the limits
for
a Class
A
digital
device,
pursuant
to
part
l5
of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This
equipment
generates,
uses, and can
rqdiate radio
frequency
energ/ and, if not installed and used in
accordance with the instruction
manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residentiql
area is likely to cause harmful
interference
in which case the user will be required to correct
the interference at his
own expense.
In regard to
RSS-Gen,
Section 8.3 the
following will be added to the user
manual:
This radio transmitter, l3SY-LCN7330P, has been
approved by
Industry
Cqnada
to operatewith the antennq types
listed below with the maximum
permissible gain
indicated.
Antenna
types
not included
in this list, having a
gain
greater
than the maximum
gain
indicated
for
that
type, are strictly
prohibited
for
use
with this device. The only
antenna approvedfor use with this device is
the antenna shown
in
the antenna
exhibit
(SmartDisk
Antenno 707|XX
with cable not exciding 0.5 m and mqximum
gain
of 3.lSdBi).
Yours
Sincerely,
Sr.
Test
Development
Test Engineer
Philips Lighting
Electronics
N.A.
Tel:
800.322.2086
Fax:
888.423.1882
www.
phi
lips.com/advance