DL8781-DL8780_4222_100_4583_1_FRONT-COVER_A5_sc.
1 3 4 5 1 6 2 10 11 12 7 8 9
English 6
English Contents Introduction 7 General Explanation of symbols 7 7 General description (Fig.
English Radio interference RF Radiation exposure statement BlueTooth wordmark App Store and iPhone Google Play and Android 7 24 25 25 25 25 Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. General This Philips body analysis scale offers you a convenient tool to measure your weight. The scale enables you to perform a body weight and fat measurement.
English Indicates the need for the user to consult the instructions for use for important cautionary information such as warnings and precautions that cannot, for a variety of reasons, be presented on the medical device itself. This symbol means that this device emits nonionizing radiation. All devices with RF transmitters or that use RF electromagnetic energy must have a label with this symbol. Indicates the manufacturer's serial number so that a specific device can be identified.
English 9 Intended use The Philips body analysis scale measures body weight and uses bioelectrical impedance analysis (BIA) technology to estimate body fat percentage of healthy adults. The device is intended for use in the home/domestic environment only.
English - This device should not be used by anyone who is acutely or chronically ill, suffering from a disease or taking medications that affect the amount of water in your body. The accuracy of readings for these patients has not been verified. Specific medical advice should be obtained from a physician. - This device is equipped with a data transmission function. It may emit electromagnetic energy so as to perform its intended function.
English 11 Preparing for use Inserting/removing the batteries Insert new batteries (4x 1.5V AAA alkaline) before the first use. Replace weak batteries before they discharge completely. Note: Data will be lost when the battery is completely empty. If you do not intend to use the device for a long period of time, it is advised to remove the batteries before storing. Caution: Replace all four batteries at the same time. Do not mix the old batteries with the new ones. This device has a battery low indication.
English 3 Close the battery compartment and wait until the digits “0.0lb” are shown on the display. You can change measurement 'Setting the measurement unit' section. Placing the carpet feet Soft surfaces such as carpet will affect the performance of the device. Always install the supplied carpet feet in case you place the device on a soft surface to prevent the soft surface from affecting the performance. 1 Remove the non-slip pads from the feet of the device.
English 13 2 Press the measurement unit button again to switch between the available measurement units: kilograms, pounds and stones. 1x 1x Pairing the body analysis scale to your mobile device and create a user profile Your Philips body analysis scale is equipped with Bluetooth® Smart. Download the Philips HealthSuite health app from the App store or Google Play. Use the search term 'Philips HealthSuite health app'. The app is available for iOS® 8.0+ and AndroidTM 4.4+.
English Measuring weight and body fat Tips for proper measurement To ensure accurate measurements, please follow these instructions when you start measuring. - Place the device on a flat, hard surface. Soft surfaces such as carpet affect the performance of the device. If you use the device on a soft surface, make sure you attach the carpet feet supplied to the feet of the device (see 'Placing the carpet feet'). This helps to prevent soft surfaces from affecting the performance of the device.
English - 2 - - 3 15 Keep the mobile device and the scale at transmission distance (no more than 16 feet / 5 meters from each other, in the same room). The Bluetooth® symbol lights up when the scale is connected to the mobile device. The Bluetooth® symbol flashes when data transmission has succeeded. Step onto the scale to switch it on. The scale beeps to indicate that it is ready for weighing.
English your weight and perform BIA. You can also upload your measurement data to the health app later on, when the scale and your mobile device are connected. Results of the body analysis measurement can only be accessed using the Philips HealthSuite health app. The scale cannot directly communicate BIA results to the user. 1 Step onto the scale barefoot to switch it on. The device beeps to indicate it is ready for weighing. - You can take a measurement barefoot.
English - 17 To select the correct user profile, step off the device and tap on the measurement platform to confirm the correct user profile. All profiles will be shown alternately on the display. Tap on the scale to confirm your user profile. Make sure that you select the correct user. Factory reset To add up to 8 new user profiles or delete all measurement results from the device, you can perform a factory reset.
English - Dispose of batteries properly. Do not incinerate. Batteries may explode if overheated. - Do not wrap in metal or aluminum foil. Tape the waste battery terminals before discarding. - It is suggested that you contact your local town or city to determine proper battery recycling site(s) in your area. - Battery must be removed from the device before discarding. Assistance For assistance, visit our website: www.philips.
English 19 Problem Possible cause Solution The display shows ---and shuts down. Maximum weight limit is reached. The scale has a weight limit of 28st 5 lb (397 lb) / 180 kg. The scale can accommodate a maximum of 28 st 5 lb (397 lb) / 180 kg. Stop using this device. The display shows the battery low symbol and switches off after a few seconds. The batteries are almost empty. Replace all four batteries at the same time. We advise you to replace batteries before they are completely empty. Use 4x 1.
English Problem Possible cause Solution When the profiles were shown alternately on the display, you selected the wrong profile. Repeat the measurement and confirm the correct user profile by tapping on the scale. You are standing on the measurement platform wearing socks or shoes. Make sure you are barefoot during the BIA measurement and keep full contact with the measurement platform. Make sure your feet are clean and slightly damp. Specifications Product name.
English 21 Degree of protection IP22 against harmful ingress of water of particular matter Applied part (measurement platform) Type BF Protection against electric shock Internally powered The device is not suitable for use in the presence of flammable anesthetic mixtures with air or with oxygen or nitrous oxide. Electromagnetic emissions and immunity The device is approved according to EMC safety standard EN 60601-1-2. It is designed to be used in typical domestic environments.
English Emissions test Compliance RF emissions CISPR 11 Class B Harmonic emissions IEC 61000-3-2 Not applicable Voltage fluctuations/flicker emissions IEC 61000-3-3 Not applicable Electromagnetic environment guidance Table 2 Guidance and manufacturer's declaration – electromagnetic immunity – for all ME equipment and ME systems Guidance and manufacturer’s declaration – electromagnetic immunity The device is intended for use in the electromagnetic environment specified below.
English 23 d = 1.167 ÖP 80 MHz to 800MHz d = 2.333 ÖP 800 MHz to 2.5 GHz where P is the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer and d is the recommended separation distance in metres (m). Field strengths from fixed RF transmitters, as determined by an electromagnetic site survey (a), should be less than the compliance level in each frequency range (b).
English Separation distance according to frequency of transmitter (m) 0.1 0.369 0.369 0.738 1 1.167 1.167 2.333 10 3.690 3.690 7.378 100 11.67 11.67 23.33 For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
English 25 RF Radiation exposure statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. For handheld/body-worn operation, this equipment has been tested and meets the FCC RF exposure guidelines. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Use of other accessories may not ensure compliance with FCC RF guidelines. Do not attempt to repair or modify this equipment.
empty page before backcover
Specifications are subject to change without notice. © 2016 Koninklijke Philips N.V. All rights reserved Manufactured for: Philips Consumer Lifestyle A division of Philips Electronics North America Corporation P.O. Box 10313, Stamford, CT 06904 4222.100.xxxx.