DL8740 Specifications are subject to change without notice. © 2016 Koninklijke Philips N.V. All rights reserved Philips Personal Health Solutions High Tech Campus 37 5656 AE Eindhoven, The Netherlands 4222.100.5746.
1 1 2 3 4 5 6 10 7 11 8 9 12 English Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Intended use The product is intended for measuring the temperature of the human body. The device is intended for all ages in a home environment.
- - - The device is not intended as a substitute for consulting a doctor. Measurement results are for reference only. When the device is used to measure the temperature of a child, it has to be operated by an adult. Adults can measure their own temperature. If you clean the ear, wait 5-10 minutes before you use the device. Earwax in the ear canal may cause inaccurate measurements. Make sure the ear canal is clean before you use the device.
Cleaning the infrared sensor To achieve accurate measurements, it is important to check if the infrared sensor is clean. Use a cotton swab to clean the infrared sensor. See chapter Cleaning and storage for instructions. After cleaning, wait approximately 5-10 minutes before you use the device. Cleaning the ear Earwax in the ear canal may cause inaccurate measurements. Make sure the ear canal is clean before you use the device. Carefully clean your ear canal.
- Once successfully connected, the measurement results will be automatically transmitted to your mobile device via Bluetooth. If the data transmission is successful, the measurement results are displayed in the Philips HealthSuite health app. The time and date of each measurement is shown in the Philips HealthSuite health app. Removing/inserting batteries When the batteries are almost empty, the display shows a flashing battery symbol and the text "bAtt' (Fig. 14).
Problem The thermometer seems to be inaccurate or the measurement results seem questionable. Possible cause Solution The poles of the batteries point in the wrong direction. Remove the batteries and reinsert them properly. The batteries are not making proper contact. Remove the batteries and reinsert them properly. The measured temperature is lower than 90.3 °F / 32.4 °C or higher than 109.2 °F / 42.9 °C. Follow the instructions in the user manual for proper measurement.
App Store and iPhone App Store and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc. Google Play and Android Google Play and Android are trademarks of Google Inc. EMC Guidance - The ear thermometer needs special precautions regarding EMC and needs to be installed and put into service according to the EMC information provided in this document.
Immuni IEC ty test 60601 test level Com pliance level Electromagnetic environment guidance Electro ±6 kV static contact dis ±8 kV air charge (ESD) IEC 61000- 4-2 ±6 kV Floors should be contact wood, concrete or ceramic tile. If ±8 kV floors are covered air with synthetic material, the relative humidity should be at least 30%.
Separation distance according to frequency of transmitter (m) 100 11.67 11.67 23.33 For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer. NOTE 1 At 80MHz and 800MHz, the separation distance for the higher frequency range applies.