DL7421, DL7422 Philips health band Specifications are subject to change without notice Find the latest user manual on www.philips.com/support © 2017 Koninklijke Philips N.V. All rights reserved Manufactured for: Philips Consumer Lifestyle a division of Philips North America LLC P.O. Box 10313, Stamford, CT 06904 4222.100.6855.
1 1 2 4 3 5 6 7 8 English General description The numbers below refer to the numbers shown in the overview image (Fig. 1). 1 Display 2 Wristband 3 Housing 4 Buckle 5 Charger 6 Release tab 7 Charging pins 8 USB connector Intended use Philips health band measures, tracks, and analyzes movement and physiological parameters. These metrics are intended as input for behavioral change programs for managing lifestyle of individuals with risk of or affected by weight and activity related chronic disease.
- - - - - - - - - - It is important to always listen to your body first, instead of only relying on measurements of the health band. Too intense exercising may cause health problems like feeling dizzy or faint, nausea, temporary chest pain or exhaustion. Consult your doctor before you start exercising in the following situations: - If you have heart disease, kidney disease and/or diabetes mellitus type 1 or 2.
- - - - - Make sure the device is in proper working condition before use. Do not wear the device when showering, bathing, swimming or scuba diving, as this may damage the device. The device is rain, splash and sweat resistant. If you travel by plane, contact your airline to determine if Personal Electronic Devices (PEDs) like the Philips health band can be used during the flight. The device uses Bluetooth Low Energy, which should be considered safe for most airlines.
2 Once successfully connected, the measurement results are synced to the Philips HealthSuite health app. If the sync is successful, the measurement results are displayed in the Philips HealthSuite health app, where you can check your personal health data. Note: Some health parameters, like resting heart rate, take up to 24 hours to start displaying data. Note: If you are unable to sync, see chapter 'Troubleshooting' for more information.
- Do not wear the health band too tight, as this may reduce the blood flow. Try loosening the strap a notch to relieve some pressure, but make sure the health band still has a snug fit. - Blood flow in the skin can also be reduced when you exercise outdoors and it is (too) cold. Wear warm clothes and gloves during outdoor exercise in cold weather. - Warm-up exercises may cause temporary inaccurate measurements as more blood flow may be directed to the muscles.
hours or AM/PM) are adopted from your phone settings. Heart rate Single tap on the time screen to go to the heart rate screen. This screen shows your heart rate values and heart rate zones. Current heart rate Your current heart rate is shown in beats per minute (bpm). Heart rate zones Heart rate zones span the range between your resting heart rate and your maximum heart rate and can help you identify the intensity of your exercise.
alarm passes. After 9 minutes the alarm will go off again. Note: When you set an alarm in the app, make sure you sync with the health band. After syncing, the health band will show an alarm icon on the display. The silent alarm is now set. Additional heart rate measurements The Philips health band measures resting heart rate and heart rate recovery. These measurements are not shown on the health band, but are available in the app. Below you can find more information.
4 Open the app again and go to the app settings. Add your new health band. 5 Follow the instructions in the app to set up a new pairing connection with your new health band. Serial number When the health band is placed in the charger, you can access the serial number. Double tap to wake up the display. Then tap until you see a 32 digit number, this is the serial number of the health band.
Problem Possible cause and Solution Pairing / syncing was unsuccessful. Bluetooth is switched off, internet is switched off or the location based service is switched off on your smartphone (location-based service only for Android). Activate Bluetooth, internet and location based services (Android only) on your smartphone. The health band is in sleep mode, which switches off Bluetooth. Make sure that the sleep mode is deactivated on the health band.
interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Do not attempt to repair or modify this equipment. Any repairs or alterations made by the user to the equipment may void the warranty and compliance of the equipment.
Feature Specification Measure ment range Heart rate: 30-200 beats per minute (bpm). Resting respiration rate: 5-45 breaths per minute Accuracy Heart rate: ± 10 bpm or 10% (whichever is greater) Resting heart rate: ± 3 bpm Total energy expenditure: ± 15% Resting respiration rate: ± 5 breaths per minute Steps: ± 5% Activity recognition (walking, running, cycling, other): 90% accurately classified Normal operating conditions Temperature: 5 °C / 41 °F to 40 °C / 104 °F. Relative humidity: 15% to 93% RH.
