Instructions / Assembly

INSTALLATION INSTRUCTIONS
INSTALLING PEST ARMOR ON OFFSET SURFACES
› Lay out sections of Pest Armor along the offset surface.
› Install each section of Pest Armor by applying downward pressure
to the bottom tab, while pushing up towards the second surface.
Secure the bottom tab every 12”, using neoprene-washered screws
(included), keeping the Pest Armor tight to both surfaces.
› Overlap all seams 1”.
TURNING PEST ARMOR 90° ON OFFSET SURFACES
› At the point of your desired 90° turn, make 1 relief cut on the top
tab of your Pest Armor. Bend the Pest Armor 90° to meet the offset
surface.
› Flatten and secure the top tab as needed. Secure the bottom tab
every 12” using neoprene-washered screws (included).
› If necessary, add relief cuts to the bottom and middle tab to allow
Pest Armor to flex for compounding angles (such as a roof ridge
vent end cap). Start in the middle of the end cap for the first relief
cut and then add one relief cut on each side, approximately 1” from
the center cut. Add more cuts as necessary.
PAINT ALL EDGES THAT HAVE BEEN CUT DURING INSTALLATION TO SEAL
AND PROTECT PEST ARMOR FROM RUST OR CORROSION