Quick Start Guide

Industry Canada
This device complies with Industry Canada license exempt RSS
standard(s): Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference
that may cause undesired operation of the device.
The term “IC:” before the certiication/registration number only
signiies that the Industry Canada technical speciications were met.
This product meets the applicable Industry Canada technical
speciications.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
FCC Warning:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the Federal
Communications Commission (FCC) rules. These limits are designed
to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modiications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including
interference that may cause undesired operation.
RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth
for an un-controlled environment. This transmitter must not be
colocated or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Cet émetteur doit être installé pour fournir une distance de
séparation d’au moins 20cm de toute personne
KODAK
RANGE EXTENDER
Quick Start
Guide
Guide de
démarrage
rapide
minimum
16ft (5m)
CHERISHCHERISHCHERISHCHERISHCHERISHCHERISHCHERISH