User's Manual

Insynctive

™

CELLULAR SHADE

Installation Instructions

INSYNCTIVE

™

PRODUCTS NEEDED

CELLULAR SHADE (included): CELLULAR SHADE can be automatically raised and lowered to improve the

comfort and convenience of your home.

REMOTE (required — sold separately): REMOTE is used to operate one or more INSYNCTIVE

SHADES

or BLINDS. REMOTE is also used to program up to three custom settings to INSYNCTIVE

SHADES or

BLINDS.

BRIDGE (optional — sold separately): The main control unit for this system, BRIDGE provides the

communication link to/from CELLULAR SHADE or your gateway home automation system. If using a

home automation system with Z-Wave, BRIDGE must be located in the same room and not more than

50 feet away from the Z-Wave gateway.

TOOLS REQUIRED

Measuring Tape

Drill with 3/32” Bit and 1/4” Nut Driver

Pencil

#2 Phillips Head Screwdriver

Flat Head Screwdriver

Level

Read and understand all instructions prior to installation. Complete all instructions prior to use. If the

installation area is out of reach, use an appropriately sized ladder and safely follow manufacturer’s

instructions for use.

INSTALLATION AND SETUP INSTRUCTIONS

1. Get Started

• Verify package contents match the packing slip

• Verify there are no obstructions in the path the shade will travel such as latches, locks, window

crank, handles, sensors, window mullions, etc.

2. Determine Mount Type

PAGE 1
Insynctive CELLULAR SHADE Installation Instructions ™ INSYNCTIVE™ PRODUCTS NEEDED CELLULAR SHADE (included): CELLULAR SHADE can be automatically raised and lowered to improve the comfort and convenience of your home. REMOTE (required — sold separately): REMOTE is used to operate one or more INSYNCTIVETM SHADES or BLINDS. REMOTE is also used to program up to three custom settings to INSYNCTIVETM SHADES or BLINDS.
PAGE 2
• Determine whether you will use a Top Mount or Back Mount. Top Mount is typically used for an inside or ceiling mount. Back Mount is typically used for outside mount. 3. Install Shade • Measure 6 inches inward from each side of the opening. Mark with a pencil. If your shade has more than two brackets, the remaining brackets must be distributed evenly between the two marks. Temporarily place each bracket and mark the screw holes. • Drill holes at the marked locations using a 3/32” bit.
PAGE 3
• Press the DOWN button to move CELLULAR SHADE to the down position. Verify CELLULAR SHADE appears straight, level, and that the gaps or overlaps are equal. Safely make adjustments to the brackets as needed. FCC Compliance and Industry Canada This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.