User Manual

C281M-C (10/99)
CM400
Corner Mount Adapter
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should only be done by qualified service personnel and conform
to all local codes.
2. Installation shall be done in accordance with all local and national electrical and mechani-
cal codes utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maxi-
mum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.
5. To prevent damage from water leakage when installing a mount outdoors on a roof or
wall, apply sealant around the bolt holes between the mount and mounting surface.
3500 Pelco Way,
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel [phone]
FAX [phone]
International Customers:
Tel [phone]
FAX [phone]
www.pelco.com
DESCRIPTION
The CM400 Corner Mount Adapter is designed for use with the LWM41 Legacy
®
Series Wall
Mount when mounting on the corner of a structure is required.
The CM400 is fabricated from aluminum and will support up to 75 lb (33.75 kg).
INSTALLATION
When mounting the CM400 to a wall, make certain that the mounting surface is capable of
supporting the full load of the mount, pan/tilt, enclosure, and camera.
1. Drill holes in the mounting surface using the CM400 mount as a template and attach the
mount securely with fasteners of a suitable size.
2. Attach and secure the LWM41 Wall Mount to the four 5/16-inch studs provided on the
CM400 with the supplied hardware.
3. Attach the pan/tilt and enclosure to the LWM41 Wall Mount according to the instructions
provided with the mount.
Block-Off Plate Installation
Included with the CM400 is a block-off plate. Depending on the particular installation require-
ments of the CM400 and LWM41 Wall Mount, the supplied block-off plate may be used as
follows:
The block-off plate or “gland” plate is designed to be used with the CM400 as a means to
close the 2.5-inch diameter hole in the mounting flange of the wall mount. If feedthrough wiring
from the mount through the CM400 is not needed, then the block-off plate may be installed
between the LWM41 and the CM400. This block-off plate installation will protect the internal
cavity of the wall mount. It is recommended that the block-off plate be used in outdoor applica-
tions.
NOTE: Fasteners to secure the
CM400 to a load-bearing solid
surface are not supplied.
NOTE: Conduit knockouts are
supplied on the block-off plate,
offering greater flexibility in in-
stallation options.