I N S T A L L A T I O N C11-UM, CM1751, and TB1751 Mounts Wall, Ceiling, Pedestal, T-Bar, Gang Box Mounts for Cameras C2301M (4/18)
Important Safety Instructions 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes. 2. Use only installation methods and materials capable of supporting four times the maximum specified load. 3. Use stainless steel hardware to fasten the mount to outdoor surfaces. 4. To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply sealant around the bolt holes between the mount and mounting surface.
Installation CM1751 MOUNT 1. Apply a drop of thread adhesive to the threads of both sides of the Extension Tube that will be used. Discard the unused Extension Tube. 2. Screw the Extension Tube to the Ball Socket Assembly until hand tight. Screw on the mounting base to the other end of the Extension Tube until hand tight. Figure 1. Attach the Extension Tube Figure 2. Screw on the Mounting Base 3.
TB1751 MOUNT 1. Squeeze the T-rail clip onto the T-bar. Figure 4. Attach the TB1751 Mount to the T-bar 2. Apply a drop of thread adhesive to the external threads of the Extension Tube that will be used. Discard the unused Extension Tube. 3. Screw the Extension Tube to the Ball Socket Assembly until hand tight. Figure 5. Attach the Ball Socket Assembly to the Extension Tube 4. Attach the ball socket/extension tube assembly to the threaded stud on the T-rail clip. Figure 6.
C11-UM MOUNT 1. Pull the wire and cable for the camera through the mounting plate and then attach the mounting plate to the mounting surface (hardware not supplied). Figure 7. Attach the C11-UM Mount to the Mounting Surface 2. Apply a drop of thread adhesive to the external threads of the Extension Tube that will be used. Discard the unused Extension Tube. 3. Screw the Extension Tube to the Ball Socket Assembly until hand tight. Figure 8. Attach the Head of the C11-UM Mount Figure 9.
4. Attach the ball socket/extension tube assembly to the threaded stud on the mounting plate. Figure 10. Attach to the Threaded Stud on the Mounting Plate CAMERA 1. Attach the camera to the 1/4-20 threaded stud on the swivel head and tighten the nuts against the camera. 2. Loosen the locking arm on the swivel assembly, if necessary. Position the camera in the desired position and tighten the locking arm. 3.
WARRANTY STATEMENT For information about Pelco’s product warranty and thereto related information, refer to www.pelco.com/warranty. REVISION HISTORY Manual # C2301M Date 4/2018 Comments Original version. Pelco, the Pelco logo, and other trademarks associated with Pelco products referred to in this publication are trademarks of Pelco, Inc. or its affiliates. ONVIF and the ONVIF logo are trademarks of ONVIF Inc. All other product names and services are the property of their respective companies.
www.pelco.com Pelco, Inc. Worldwide Headquarters 625 W.