Installation Manual

Table Of Contents

INSTALLATION

BU-ADAPTER

C3911M (03/12)

Important Safety Instructions

1. Installation and servicing should be done only by qualified service personnel and conform to all local codes.

2. Use only installation methods and material capable of supporting four times the maximum specified load.

3. Use stainless steel hardware to fasten the mount to outdoor surfaces.

4. To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply sealant around the bolt holes between the mount

and mounting surface.

Description

The BU-ADAPTER is used when installing the BU Series camera system to a wall or ceiling that requires surface mounted conduit.

It can be used with specific conduit boxes. See “Specifications” for details.

Package Contents

• One installation manual

• One rubber and three M4*0.7P, 12mm screws (for BU4/BU5 series only)

• One rubber and four M4*0.7P, 15mm screws (for BU6 series only)

Note: The cable hole of rubber for BU4/BU5 series is smaller than BU6 series.

Installation

You can use BU-Adapter with the recommended conduit boxes to protect cables from rain, heat, vandals and other

harsh factors and make a tidy, professional installation on a surface mount installation.

Descriptions for the Figure 1 Installation Guide (typical):

① Camera bracket(BU4/BU5 series shown)

② Camera cables

③ Rubber of BU-Adapter

④ Screws(provided)

⑤ Metal plate of BU-Adapter

⑥ Conduit box(See “Specifications” for details)

Installation Procedures(typical)：

1. Pass all cables through the hole of rubber.

Note: Please identify both sides of the rubber. The side of the rubber with the inclined

angle must be towards the terminals of the cables and metal plate to avoid water

leakage. Refer to the figure below.

2. Insert the rubber into the center hole of metal plate.

3. Then install the metal plate in the conduit box and tighten the screws and finish the

installation.

Figure 1 Installation Guide

PAGE 1
INSTALLATION BU-ADAPTER C3911M (03/12) Important Safety Instructions 1. Installation and servicing should be done only by qualified service personnel and conform to all local codes. 2. Use only installation methods and material capable of supporting four times the maximum specified load. 3. Use stainless steel hardware to fasten the mount to outdoor surfaces. 4.
PAGE 2
Specifications Construction Finish Weight Aluminum Silver liquid painting 100g The BU-Adapter can be used with the following conduit boxes: Manufacturer Teddico/BWF Teddico/BWF Raco Part Number RB-7V RB-5V 5361-0 Raco 5372-0 Orbit RB50-5 Orbit RB75-5 EGS EGS WRX50 WRX75 Description ROUND OUTLET BOX 3/4” GREY 5 HOLE ROUND OUTLET BOX 1/2” GREY 5 HOLE 4” Round Weatherproof Splice Box 5-1/2” Outlets 4” Round Weatherproof Splice Box 5-3/4” Outlets 4” ROUND 1/2” THREADED HOLE OUTDOOR WEATHERPROOF BOX
PAGE 3
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years: – Fiber optic products – Unshielded Twisted Pair (UTP) transmission products – CC3701H-2, CC3701H-2X, CC3751H-2, CC3651H-2X, MC3651H-2, and MC3651H-2X camera models • Three years: – FD Series and BU Series analog camera models.