• Accessories Installation Instructions Mercedes-Benz Cradle adaptor with Bluetooth® wireless technology 5. Entwurf GEN II 01.06.
Mercedes-Benz Cradle adaptor with Bluetooth® wireless technology 1 M+P-03F-6662
The Mercedes-Benz approved/ recommended Bluetooth® Phones can be utilized inside Mercedes-Benz vehicles. Application These installation instructions are valid for vehicles with an MHI hands-free communications systems and a Mercedes-Benz-approved Bluetooth® mobile telephone. Approved mobile telephones are listed and can be purchased on the Internet at www.wireless4mb.com or call 1-800-266-7746 to speak to a wireless activation specialist.
Notes The manufacturer reserves the right to change technical details from those shown in the illustrations contained in these installation instructions. These installation instructions also refer to the vehicle Operator's Manual, COMAND Operator's Manual, and mobile telephone manual. Please refer to them for reference. Use of a mobile telephone other than a Mercedes-Benz approved/recommended model may result in improper performance and cannot be equipped or serviced by Mercedes-Benz.
Pairing the mobile telephone with the Mercedes-Benz Cradle adaptor with Bluetooth® Make sure that the starter switch is in position 1, 2 or 3 (see the vehicle Operator's Manual). 4 3 M+P-03F-6664 1. With Mercedes-Benz Cradle adaptor with Bluetooth® connected to the vehicle press button (3) for approx. 2-3 seconds. The LED (4) will begin to flash rapidly. The Mercedes-Benz Cradle adaptor with Bluetooth® is in Discovery Mode and can be detected by a Bluetooth® mobile telephone.
2. For instructions on how to get the mobile telephone ready for pairing, see the mobile telephone manual or visit www.wireless4mb.com. Once the mobile telephone and Mercedes-Benz Cradle adaptor with Bluetooth® find each other the mobile telephone will prompt the user to enter a Pass-Key. Note Located on the backside of the Mercedes-Benz Cradle adaptor with Bluetooth® there will be a sticker containing the Pass-Key (5). 4. When prompted, enter the Pass-Key into the mobile telephone.
Establishing a Bluetooth® Connection Notes A maximum of 4 mobile telephones can be paired with the Mercedes-Benz Cradle adaptor with Bluetooth®. However, only one mobile telephone is connected to the Mercedes-Benz Cradle adaptor with Bluetooth® at a time. If a fifth mobile telephone is paired with the Mercedes-Benz Cradle adaptor with Bluetooth®, then the information stored from the first mobile telephone which was paired with the Mercedes-Benz Cradle adaptor with Bluetooth® will be replaced.
When using Bluetooth® the mobile telephone uses more power. Since the mobile telephone is not being charged the battery should have a sufficient charge. SMS messages can not be accessed via the COMAND or radio while the Bluetooth® connection is established. Not every ring-tone of the mobile telephone is supported by the COMAND or radio. 3-way-calling and call waiting are not supported from the Mercedes-Benz Cradle adaptor with Bluetooth®. An audible peep will notify a waiting call.
Connecting the mobile telephone and Mercedes-Benz Cradle adaptor with Bluetooth® manually Valid for all Mercedes-Benz vehicles with the exception of the model year 2007 S-Class: • Press button on the COMAND or radio. Model year 2007 S-Class vehicles: • Using the COMAND Controller, select "Telephone" 씮 "Telephone" 씮 "Telephone on". Note Before manual connection, the mobile telephone must previously be paired with the Mercedes-Benz Cradle adaptor with Bluetooth® (see pairing procedure on page 3).
Disconnecting the Bluetooth® connection automatically The connection between the Mercedes-Benz Cradle adaptor with Bluetooth® and the mobile telephone is automatically disconnected when the mobile telephone travels outside of the range (approx. 30 ft) of the Mercedes-Benz Cradle adaptor with Bluetooth®.
Detaching the Mercedes-Benz Cradle adaptor with Bluetooth® 2 7 1 8 M+P-03F-6666 Press and hold the release button (6). Slide the Mercedes-Benz Cradle adaptor with Bluetooth® (1) in direction of arrow (7) and remove it from the pre-installed contact plate (2). Note This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference.
© 2006, Mercedes-Benz Accessories Inc. Not to be reprinted, translated or otherwise reproduced, either wholly or in part. Mercedes-Benz Accessories Inc., Stuttgart · A DaimlerChrysler AG Company 06/06 03F037-05 Order No.