2.Prüfentwurf 03F037-08 23.04.
USA Mercedes-Benz Bluetooth® Cradle for Motorola mobile phones RAZR² V9 and RAZR² V9m 1 M+P-03F-7160
USA Application These installation instructions are valid for vehicles with an MHI hands-free communication system and a Mercedes-Benz-approved Motorola mobile phone RAZR² V9 or RAZR² V9m with approved software level. Approved mobile telephones are listed and can be purchased on the Internet at www.wireless4mb.com or call 1-800-910-1021 to speak to a wireless telephone specialist. Parts included • (1) Mercedes-Benz Bluetooth® Cradle GWarning Always use approved phones with the Mercedes-Benz Cradle.
Notes The Motorola RAZR² V9 will not fit in the Mercedes-Benz Bluetooth® Cradle for Motorola RAZR² V9m and the Motorola RAZR² V9m will not fit in the Mercedes-Benz Bluetooth® Cradle for Motorola RAZR² V9. Please contact your local Mercedes-Benz Center if you encounter difficulties when operating the Mercedes-Benz Hands-Free Communication System. More information can be found on the Internet at www.wireless4mb.com or call 1-800-910-1021 to speak to a wireless activation specialist.
Installing the Mercedes-Benz Cradle 2 1 M+P-03F-7161 1. Insert the Mercedes-Benz Cradle (1) into the latches on the pre-installed MHI contact plate (2), located in the center console. To insert the Mercedes-Benz Cradle (1), slide it upwards until it clicks into place.
Inserting mobile telephone The Motorola RAZR² V9 phone can only be used inside of the Mercedes-Benz Cradle for use in hands-free mode. The Mercedes-Benz Cradle uses Bluetooth® technology to connect with your Motorola RAZR² V9 phone. Make sure you have established a Bluetooth® connection before using the Mercedes-Benz Cradle, see pairing procedure on page 6.
4 3 5 M+P-03F-7163 3. Mobiltelefon (4) zunächst unten in die Aufnahme (3) einsetzen und anschließend komplett einlegen. 4. Aufnahme (3) nach links zuschieben; dabei darauf achten, dass • der Stecker (5) am Mobiltelefon (4) einrastet und • die seitlichen Tasten am Mobiltelefon (4) nicht betätigt werden. 5. Aufnahme (3) mit Mobiltelefon (4) zurückdrücken, bis sie einrastet.
Pairing the Motorola RAZR² V9 phone with the Mercedes-Benz Cradle Zum Koppeln muss sich das Mobiltelefon außerhalb des Halters im Fahrzeug befinden. 1. Make sure that the ignition switch is in position 1, 2 or 3 (see the Vehicle Operator’s Manual). 7 6 M+P-03F-7164 1. With Mercedes-Benz Cradle connected to the vehicle press button (6) for approx. 2–3 seconds. The LED (7) will begin to flash rapidly. The Mercedes-Benz Cradle is in Discovery Mode and can be detected by the Motorola RAZR² V9 phone.
Note As soon as the Pass-Key has been entered and accepted, you will see a display message on your mobile phone indicating that the connection has been established. The connection between the mobile phone and the cradle is cut off automatically. 4. The Motorola RAZR² V9 phone is now ready for use with the Mercedes-Benz Hands-Free Communication System. Note A maximum of 4 Motorola RAZR² V9 phones can be paired with the Mercedes-Benz Cradle.
Not every ring-tone of the Motorola RAZR² V9 phone is supported by the COMAND or radio. 3-way-calling and call waiting are not supported in the Mercedes-Benz Cradle. An audible beep will notify a waiting call. The roaming indication is not supported by the COMAND or radio. The Tele Aid System (emergency call system) will continue to function independently of the hands-free phone system as designed as long as there is a valid service contract, telephone service and a GPS coverage.
Disconnecting the Bluetooth® connection The connection between the Motorola RAZR² V9 phone and the Mercedes-Benz Cradle is automatically disconnected when the Motorola RAZR² V9 phone is removed from the Mercedes-Benz Cradle. Note Ein aktives Gespräch wird durch die Entnahme des Mobiltelefons aus dem Mercedes-Benz Cradle beendet. Removing Motorola RAZR² V9 phone 3 4 M+P-03F-7165 1. Auf das Mobiltelefon (4) drücken; die Aufnahme (3) schwenkt selbstständig auf. 2.
3 4 M+P-03F-7166 3. Mobiltelefon (4) wie abgebildet aus der Aufnahme (3) entnehmen. 4. Aufnahme (3) nach links zuschieben und zurückdrücken, bis sie einrastet. Detaching the Mercedes-Benz Cradle 8 2 1 M+P-03F-7167 1. Press and hold the release button (8). Slide the Mercedes-Benz Cradle (1) downwards and remove it from the preinstalled contact plate (2).
Note This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference. • This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
© 2008 Mercedes-Benz Accessories Inc. Not to be reprinted, translated or otherwise reproduced, either wholly or in part. Mercedes-Benz Accessories Inc.
