User Manual

ManualsBrandsPeiker acustic ManualsElectronicsAdvanced telecommunication Module (ATM), telematics Control Unit

page 1

peiker acustic GmbH & Co. KG, Max-Planck-Straße 28-32, D-61381 Friedrichsdorf, Amtsgericht Bad Homburg HRA 1897

phG: peiker Verwaltungs GmbH, Amtsgericht Bad Homburg HRB 1369

Vorsitzender der Geschäftsführung: Andreas Peiker, Geschäftsführer: Reinhard Kromer-von Baerle, Mathias Köhler

Vorsitzender des Aufsichtsrates: Dr. Helmut Rothenberger Ein Unternehmen der peiker Firmengruppe

Statement for User Manual

Advanced Telecommunication Module (ATM)

ATM-01 T1-US-4GW

Rev. 1.0

Release

PEIKER acustic Confidential and Proprietary

Name of model:

ATM-01 T1-US-4GW

Internal peiker product ID:

2609-075-196-51

Status:

Release

Revision:

1.0

Date:

05.08.2015

Summary of content (8 pages)

PAGE 1
Statement for User Manual Advanced Telecommunication Module (ATM) ATM-01 T1-US-4GW Rev. 1.0 Release PEIKER acustic Confidential and Proprietary Name of model: Internal peiker product ID: ATM-01 T1-US-4GW 2609-075-196-51 Status: Revision: Date: Release 1.0 05.08.2015 page 1 peiker acustic GmbH & Co.
PAGE 2
1 Change documentation Date 05.08.2015 Revision Rev 1.0 Name M. Fleckenstein Changes / Comment Initial version page 2 The copyright protection of this original document remains with Peiker acustic GmbH & Co. KG. Without prior written authorization it shall not be copied or otherwise reproduced by a third party and shall not be disclosed to competitors. The infringement shall be strictly enforced by applicable civil and criminal legal proceedings.
PAGE 3
1 Change documentation ..................................................................................................... 2 2 Introduction ..................................................................................................................... 4 2.1. Scope ............................................................................................................................... 4 2.1.1. Purpose of the document ...........................................................................
PAGE 4
2 Introduction 2.1. Scope 2.1.1. Purpose of the document The Advanced Telecommunication Module (ATM) trunk version is manufactured by peiker acustic GmbH & Co. KG (grantee) and sold as an OEM product. According to the US Code of Federal Regulations (47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc.), the grantee must ensure the end-user has the applicable and appropriate operating instructions for the device. In the case of this product the grantee must notify the OEM to notify the end-user.
PAGE 5
3 Antenna installation To comply with the RF exposure requirements of the FCC following requirements have to be fulfilled: The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operated in conjunction with any antenna or transmitter, except in accordance with FCC multitransmitter product procedures. This device is to be used in mobile or fixed applications only.
PAGE 6
4 Wireless LAN The device contains an internal antenna for WLAN operation. Wireless LAN standards IEEE 802.
PAGE 7
5 Warning Statements for the User Manual The following certification markings and hints should be printed in the end user’s manual: 5.1. US /Canada This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
PAGE 8
6 Battery replacement Please be advised that this product will need special trained professionals in configuring and installing the product within the car. To open the battery compartment, push down the battery lid at the front of the device and shift the lid sideward. Disconnect the battery connector in order to push the locking lever and pull the connector at the same time. Release the battery and replace it with the replacement part.