Installation Manual

ManualsBrandsPeerless-AV ManualsCamera & Photo7-inch Security Camera Mount

1 of 1

ISSUED: 2-27-97 SHEET NO: 050-9001-5 11-14-13

Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.

Patented. Utility Patent No. 5,790,910; D400,085.

Installation and Assembly - Light Duty Camera Mount

IMPORTANT! Read entire instruction sheet before you start installation and assembly. Fasteners for wall attachment

to be provided by installer.

MAXIMUM LOAD CAPACITY:

10 lb (4.5 kg)

PARTS LIST

QTY. DESCRIPTION

A 1 housing

B 1 tension screw

C 1 socket

D 1 ball stud

small mounting hole

large mounting hole

cable access holes

Model: CMR 410

camera

PEERLESS 7" SECURITY CAMERA MOUNT (CMR 410)

• Installer must verify that the wall will safely

support four times the combined weight of

all attached equipment and hardware.

WARNING

Peerless is a registered trademark of Peerless Industries, Inc.

All other brand and product names are trademarks or registered trademarks of their respective owners.

Camera housing (A) may be attached to

wall or ceiling via the four large mounting

holes, or directly to a standard electrical

outlet box via two small mounting holes.

Hardware for attaching camera housing

to mounting surface is not included.

Note: Peerless Industries recommends

using #14 x 2.5 phillips hex wood screws.

Attach ball stud (D) to threaded tting

in bottom of camera. Reinsert ball

stud (D) into socket (C). Rotate and

angle camera to desired position.

Tighten tension screw (B) securely.

Note: Cable(s) may be routed

through cable access holes.

Ball Stud Removal.

Note: Ball stud removal may not be

necessary for camera attachment.

Loosen tension screw (B) several

turns. Rotate socket (C) as pictured.

Push down on ball stud (D) and

remove by passing through hole in

socket (C).