Wireless Microphone UB-7(TRANSMITTER) Operating Manual www.peavey.
Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. ENGLISH Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: Risk of electrical shock — DO NOT OPEN! CAUTION: To reduce the risk of electric shock, do not remove cover. No user serviceable parts inside.
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 9.
CUIDADO: Cuando use productos electrónicos, debe tomar precauciones básicas, incluyendo las siguientes: 1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente con una tela seca. 7. No bloquear ninguna de las salidas de ventilación. Instalar de acuerdo a las instrucciones del fabricante. 8.
ATTENTION: L’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions. 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité proche de plans d’eau. 6. N’utilisez qu’un tissu sec pour le nettoyage de votre unité. 7.
FCC Compliancy Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, that may cause undesired operation. Warning: Changes or modifications to the equipment not approved by Peavey Electronics Corp. can void the user’s authority to use the equipment.
ENGLISH INTRODUCTION Please read this manual thoroughly for correct operation and optimal performance. PV® 16 Channel Dual Receiver PLL Wireless Receiver Features 4 6 1 7 3 8 4 6 2 7 3 8 2 5 5 FRONT PANEL (1) Power switch (2) Infrared(IR) port: Broadcasts IR signal to transmitter. (3) Channel indicator: To display system’s receiving channel. (4) DIV indicator: Antenna receiver status indicator LED. (5) AF1 - AF5 indicator: Indicate the audio signal level. (6) UP select button.
PV® 16 Channel Dual Receiver PLL Wireless Receiver Features CH 2 CH 1 ANT A ANT UNBALANCED AUDIO OUT OUTPUT 9 9 10 11 10 11 12 13 BACK PANEL (9) Antenna connectors (10) Balanced out Jack: XLR connector provides balanced audio output signal from this jack to the amplifier. (11) Volume adjustment knob: Adjusts the volume level of the AUDIO OUT. 14 15 (12) Unbalanced out Jack: MIX OUTPUT, with Phone Jack provides audio output signal from this jack to the amplifier.
Green Flashing green Ready Amber Flashing red Controls locked Mute on IR transmitter in process Glowing red Battery power low Pulsing red on startup Batteries dead(transmitter cannot be turned on until batteries are changed) Pulsing red after synchronization Transmitter and receiver are incompatible CHANGING BATTERIES • Expected life for alkaline batteries is approximately 8 hours. • When the transmitter light glows red, the batteries should be replaced, as shown.
PV® 16 Channel Dual Receiver Body Pack Transmitter 20 17 18 21 25 22 19 26 23 24 Green Flashing green 27 Ready Amber Flashing red Controls locked Mute on IR transmitter in process Glowing red Battery power low Pulsing red on startup Batteries dead(transmitter cannot be turned on until batteries are changed) Pulsing red after synchronization Transmitter and receiver incompatible BODYPACK TRANSMITTER (17) Power / Mute Button (24) Volume Adjustment (18) Mic Jack (25) Guitar Cable for gui
PV® 16 Channel Dual Receiver Body Pack Transmitter BODYPACK TRANSMITTER CHANGING BATTERIES • Expected life for alkaline batteries is approximately 8 hours. • When the transmitter light glows red, the batteries should be replaced immediately, as shown. When the Transmitter is not in use: Make sure the microphone is turned off. If the microphone will not be used for an extended period of time, please remove the batteries to avoid battery leakage that can result in damage to the battery springs and circuit.
PV® 16 Channel Dual Receiver Body Pack Sync Function <15 cm AUTOMATIC TRANSMITTER SETUP Open the body pack transmitter battery compartment to display the infrared(SYNC) port. With the transmitter SYNC port exposed to the receiver, press SYNC When the receiver ready light glows, the system is ready for use. Close the body pack transmitter battery compartment.
SPECIFICATIONS SYSTEM FREQUENCY UHF Audio Frequency Response Minimum: 50 Hz Maximum: 18 KHz +/-3 dB (Overall system frequency depends on microphone element) Total Harmonic Distortion 0.8%, typical Ref.+/-30 KHz deviation,1 KHz tone RX TX Dynamic Range >100 dB A-weighted Working Range 100 m (300 ft.) Oscillation Type ` Microprocessor controlled PLL Synthesized Receiving Method Diversity Frequency Stability +/- 0.005% No.
PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTY Effective Date: 03/04/2010 What This Warranty Covers Your Peavey Warranty covers defects in material and workmanship in Peavey products purchased and serviced in the U.S.A. and Canada.
IC warning This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
14
Features and specifications are subject to change without notice. Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.
