Manual

ManualsBrandsPayne ManualsHeating & cooling combined unitOfficial Payne central package

User's

PY1P-B / PY2P-B

Single-Packaged

Gas Heat/Electric Cooling

Unit

anual

NOTE: Read the entire instl_action manual before starting the installation

SAFETY CONSIDERATIONS

Note to Installer: This manual should be left with the equipment user

z_x WARNING: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other

appliance. Failure to follow this warning could result in fire, serious injury, or death.

Z_x WARNING: Do not use this unit if any part has been under water. _mmediately call a qualified service technician to

inspect the unit and to replace any part of the control system which has been under water. Failure to follow this warning

could result in electrical shock, fire, serious injury, or death.

Z_ WARNING: For your safety if you smell gas

l. Do not try to light any appliance

2. Do not touch any electrical switch: do not use any phone in ym/r b_/ilding.

3. [mmediately call your gas supplier from a nearby phone. Follow the gas supplier's instractions.

4. If you cannot reach your gas supplier, call the fire department.

Z_ WARNING: Before performing recommended maintenance, be sure the main power switch to unit is turned off and

lock-out tag installed. Electric shock could cause serious injury or death.

UNiT INTRODUCTION

This PY1P-B PY2P-B unit is a small packaged gas heaffelectric cooling system that can provide year-round comfort

Starting or Shutting Unit Off

NOTE: Your combination heating/cooling unit is equipped with an automatic direct spark ignition and power combustion blower,

z_ WARNING: Do not attempt to light by hand; serious injury may result.

TO LIGHT UNIT:

z_ DANGER:

l. Do not mrn off the electlical power to unit without first turnbag off the gas supply

2. Before attempting to start the gas heating section, _miliarize yourself with all the procedures that must be _bllowed.

If you do not t'ollow tlaese instructions exactly, a fire or explosion may result, causing property damage, ir{iury, or loss of life

Refer to Fig 1 or Fig 2 for location of unit access panel and gas valve Refer to Fig 3 while proceeding with the _bllowing steps

1. Set the temperature selector on room thermostat to the lowest temperature setting and set system switch to HEAT

2. (lose the external manual gas slmtoff valve

3. Turn off the electrical supply to the unit.

4. Remove the fi'ont access panel with a 5/16-in. nut driver.

5. Move the selector switch on the internal gas valve to the OFF position and wait 5 minutes.

Form: OG-PYIP-01 Cancels: OM10-18 Printed in U.S.A. 1-03 Catalog No. 53PY-1P16

Summary of content (8 pages)

PAGE 1
User's anual PY1P-B / PY2P-B Single-Packaged Gas Heat/Electric Cooling Unit NOTE: Read the entire instl_action manual before starting the installation SAFETY Note to Installer: CONSIDERATIONS This manual should be left with the equipment user z_x WARNING: Do not store or use gasoline or other flammable vapors and liquids appliance. Failure to follow this warning could result in fire, serious injury, or death.
PAGE 2
C99088 Fig, l--OnR PYIP-B ! PY2P-B 6. Move the selector switch on the internal gas valve to the ON position. 7. Replace the fl'ont access panel 8. Tu*n on the electrical supply to unit. 9. Open the external manual gas shutoff valve. 10. Set the temperature selector on room thermostat start.
PAGE 3
Table To better protect With FILTER SiZE PY1P=B 036=042 PYtP=B PYtP°B 0t8=030 048=060 ] 20 x 24 20 24 xx 20 30 and to eliminate MODE the SYSTEM o1"MODE On extremely PROCEDURE 2--GAS With the SYSTEM your system n I--COOLING have selected.
PAGE 4
f UNIT SIZE FILTER SIZE PY2P-B 024-030 20 x 20 PY2P°B 036 20 x 24 PY2P-B 042-0G0 24 x 30 ACCESS PANEL FILTER ACCESS PANEL* *For accessory filter rack. C99094 Fig. COMPRESSOR 2--Filter Access PanebVertical Supply Shown All compressors are filctory-shipped with a normal charge of the correct type refrigeration grade oil A compressor should rarely require additional oil CONDENSER (OUTDOOR) FAN z_ CAUTION: Do not poke sticks, damage may result.
PAGE 5
-F MAIN ON I I I STEP1 STEP2 I ®j STEP STEP 4 STEP STEP 6 7 MAINo N_ OFF STEP8 "--.-f_ STEP STEP 9 Fig.
PAGE 6
MAIN ON I STEP 1 LJ STEP2 STEP STEP STEP 4 3 5 I I OFF L STEP STEP 6 Fig.
PAGE 7
C. Regumar In addition technician. Dealer to the type ofrmltine maintenance you might be willing to per%rm, your unit should An inspection (preferably each year, but at least every other year) should include 1. Inspection of all flue product passages-including the burners, 2. Inspectmn of all combustion- and ventilation-air passages 3.