User's Manual

ManualsBrandsPaxton Access ManualsElectronicsOEM Plastic Reader Keypad / Mace Security Standalone Plastic Reader & Keypad

Page 1

Ins-50012-MS Mace Security stand alone plastic reader and keypad

Suitability

Fitting

Exit button

(push to make)

9-15V DC

12V DC release current rating

must be less than 1A.

(fuse rating 1A)

* The diode current rating must

be equal to or greater than the

current in the release

08/21/2009

Security sensitive doors

Wet environments

Mounted on metal surface

Readers mounted together

between readers

12 inches

User cards are NOT supplied with this unit.

Grey

Black

White

+12V DC

Securit y Pr od u c t s

Technical Support

Technical help is available: Monday - Friday 9am to 7pm (EST)

877-585-6223 support@mace.com

Documentation on all Mace Security Products can be found on our web site - http://www.macepro.com/

Summary of content (8 pages)

PAGE 1
08/21/2009 S e c u r i t y Pro d u c t s Ins-50012-MS Mace Security stand alone plastic reader and keypad Technical Support 877-585-6223 Technical help is available: support@mace.com Monday - Friday 9am to 7pm (EST) Documentation on all Mace Security Products can be found on our web site - http://www.macepro.
PAGE 2
Please read the following notes before installing Electrical shock from voltages used in this system can cause injury or death. Prior to making any electrical connections, or performing maintenance and repair, ensure power is removed. Mains electrical connections should be made only by qualified personel in accordance with local regulation. Safety goggles should be worn while using power tools. Fitting the keypad Step 1: Carefully mark out the mounting holes for the keypad and the hole of the cable feed.
PAGE 3
Setting The Master Code The first time the keypad is turned on the RED and GREEN LEDs flash alternately. This indicates a 6 digit Master Code must now be entered. »The Master Code allows access to the Programming Menu.
PAGE 4
Changing the keypad backlight Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode Press and hold for 3 seconds 0 { *# } = On press = Off Setting multiple entry codes (maximum = 120) Press # = default to exit programming mode Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode Press and hold for 3 seconds 2 { *# } = On press = Off Press # to exit programming mode When in Mu
PAGE 5
Setting the keypad for additional security Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode { *# } Press and hold for 3 seconds 4 = On # press = Off When enabled, the keypad will deactivate for 60 seconds if there are 20 consecutive incorrect numbers entered Press to exit programming mode = default Changing the Master code Enter 6 digit Master Code The RED and GREEN LEDs flash simultaneously indicating reader is in Programming Mode
PAGE 6
Adding proximity tokens Up to 2000 proximity tokens can be added to the keypad. Each token is allocated to a memory slot on the keypad. A note will need to be made of the memory slot a token is allocated to, a handy table is included in these instructions for this purpose.
PAGE 7
Technical Help Here is the list of topics about this product that receive the most technical support inquiries. We list them here to help you speed up the installation and trouble shooting process. 1. I have connected the keypad correctly. Why doesn’t it open when I enter my code? QQ QQ QQ- Check that there is power to the keypad by setting the keypad backlight to ON, and listening for keypad beeps. If not, check the power supply. Check that the green light flashes when the correct code is entered.
PAGE 8
Page