SK700 Smart Kiosk Note: Product images shown may be different than actual product received PAX TECHNOLOGY LIMITED
1、ContentsChecklist Please check the components after unpacking. If any are missing, please contact the dealer.
Front View Interface Diagram 3.
threesecondsuntil the boot animation appears. Power off: Press and hold the Power button for threeseconds until the shutdown menu displays. Select Power off. Theterminal turns off after a few seconds. 4. Payment Options Magnetic stripe card Insert magnetic stripe card into card slot and push to the end with magnetic stripe facing down, then pull out the card at a constant speed to swipe card. IC chip card Insert card with IC chip facing up, then push it to theend of the card slot.
Scan When the scan indicator is on, hold your QR code & bar code device in front of the scan window to scan code. 5、Load Printer Paper 1. Insert the key into the keyhole and turn it counterclockwise to open printer cover.
2. Completely open the printer cover. 3. Insert the new paper roll into the printer.
4. Pull out the end of the paper so that itextends past the cutting blade, Make surethe paper roll is placed in the direction asshown in the figure below. 5.Close the printer cover, and pull outthe key. Printer will automatically cut offthe extra paper, the paper is changed successfully.
6、Wall-mounted Installation Parts List No.
3 4 M6-50 Expansion Screw M4-10 Combination Screw 6 2 Installation Steps 1. Use 6pcs expansion screws to fix the bracket on the wall. • Use an 8.0 mm diameter drill bit to drill holes in the wall according to the position of the bracket fixing hole. The size is shown in the figurebelow: • Note: Holediameter is 8.0mm, Hole depth is above 60.0mm. 2.Use the 4pcs hooks on the back of the device to hang the whole device on the wall bracket.
3. Use 2pcs M4-12 combination 3screws to attach the machine to the wall bracket at the bottom of the machine. 4. The device installation is completed. 7.Usage Tips 1) There is no built-in battery, and the device can only be powered by the power adapter. 2) Avoid exposing the device in overheated, humid, dusty, or strong electromagnetic environment. 3) Do not vibrate, shake, or drop the device. 4) Do not insert or unplug any part of the device while it is powered on.
person nearby, if so, pay attention to guard against theft. FCC compliance statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
ii. where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated. i. le dispositifutilisé dans la bande 5150-5250 MHz estréservé à uneutilisationenintérieurafin de réduire le risque de brouillagepréjudiciable aux systèmes mobiles par satellite dans le même canal; ii.
