SK800 Smart Kiosk Note: Product images shown may be different than actual product received PAX TECHNOLOGY LIMITED
1、ContentsChecklist Please check the components after unpacking. If any are missing, please contact the dealer.
Interface Diagram 3、Operating Instruction · Power on: Plug in the AC power cable and turn on the power button. · Contactless module indicator: Light indication when using the Contactless module. · LED working indicator: Light indication when the device is working at night. · Card Readers: Magnetic stripe card: Insert magnetic stripe card into card slot and push to the end with magnetic stripe facing down, then pull out the card at a constant speed to swipe card.
Micro SD card slot(Support maximum of 128GB) x 1 Peripheral Ports: RJ45 (LAN) x1 RS232 (DB9)x1 RS485 Half-duplex (RJ-11) x1 HDMIPort(1.
3. Insert the new paper roll into the printer. 4. Pull out the end of the paper so that itextends past the cutting blade, Make surethe paper roll is placed in the direction asshown in the figure below. 5.Close the printer cover, and pull outthe key. Printer will automatically cut offthe extra paper, the paper is changed successfully.
、Install introduction No.
3 4 M6-50 Expansion Screw M4-12 Combination Screw 6 2 Installation Steps 1. Use 6pcs expansion screws to fix the bracket on the wall. • Use an 8.0 mm diameter drill bit to drill holes in the wall according to the position of the bracket fixing hole. The size is shown in the figurebelow: • Note: Hole diameter is 8.0mm, Hole depth is above 60.0mm. 2.Use the 4pcs hooks on the back of the device to hang the whole device on the wall bracket.
3. Use 2pcs M4-12 combination 3screws to attach the machine to the wall bracket at the bottom of the machine. 4. The device installation is completed. 7、Installation and Usage Tips 1) There is no built-in battery, and the device can only be powered by the power adapter. 2) Avoid exposing the device in overheated, humid, dusty, or strong electromagnetic environment. 3) Do not vibrate, shake, or drop the device. 4) Do not insert or unplug any part of the device while it is powered on.
5) If necessary, please contact PAX technical support for assistance with the device. 6) Before using the magnetic stripe /IC/contactless card, check if there is any suspicious person nearby, if so, pay attention to guard against theft. 8、FCC Regulations: This device complies with Part 15 of the FCC Rules.
1) 2) l'appareil ne doit pas produire de brouillage, et l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter, except tested built-in radios.
- The marking information is located at the bottom of apparatus - The equipment is only suitable for mounting at heights≤2m - Moving parts Keep body parts away from moving parts Hereby, PAX Computer Technology (Shenzhen) Co., Ltd. declares that the radio equipment type SK800 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:https://www.pax.com.cn/ProductCE/index.