SK600 Smart Kiosk Note: Product images shown may be different than actual product received PAX TECHNOLOGY LIMITED
1、ContentsChecklist Please check the components after unpacking. If any are missing, please contact the dealer.
Interface Diagram Power Port,Power Button,D89 Serial,SD Card Slot,HDMI Port,RS485 Port,Micro USB, SIM Card Slot,Ethernet Port 3、Operating Instruction · Power on: Plug in the AC power cable and turn on the power button. · Contactless module indicator: Light indication when using the Contactless module. · LED working indicator: Light indication when the device is working at night.
Micro SIM card slot x 1 Micro SD card slot(Support maximum of 128GB) x 1 Peripheral Ports: RJ45 (LAN)x1 RS232 (DB9)x1 RS485 Half-duplex (RJ-11)x1 HDMIPort(1.
3. Remove the remaining paper roll. 4. Insert the new paper roll into the printer. 5. Pull out the end of the paper so that it extends past the cutting blade, Make sure the paper roll is placed in the direction as shown in the figure below. 6.Close the printer cover, and pull out the key. Printer will automatically cut off the extra paper, the paper is changed successfully.
、Install introduction No. 1 2 3 4 Installation List Part SK600Kiosk Wall Bracket M6-60 Expansion Screw M4-12 Combination Screw Picture Qty/pcs 1 1 6 2 Installation Steps 1. Use 6pcs expansion screws to fix the bracket on the wall. • Use an 8.0 mm diameter drill bit to drill holes in the wall according to the position of the bracket fixing hole. The le size is shown in the figurebelow: • Note: Hole diameter is 8.0mm, Hole depth is above 60.0mm.
2.Use the 4pcs hooks on the back of the device to hang the whole device on the wall bracket. 3. Use 2pcs M4-12 combination 3screws to attach the machine to the wall bracket at the bottom of the machine. 4. The device installation is completed. 7、Installation and Usage Tips 1) There is no built-in battery, and the device can only be powered by the power adapter.
2) Avoid exposing the device in overheated, humid, dusty, or strong electromagnetic environment. 3) Do not vibrate, shake, or drop the device. 4) Do not insert or unplug any part of the device while it is powered on. Otherwise, it may cause damage to the internal circuit. 5) If necessary, please contact PAX technical support for assistance with the device. 6) Before using the magnetic stripe /IC/contactless card, check if there is any suspicious person nearby, if so, pay attention to guard against theft.
ISED Notice This device complies with Science and Economic Development Canada’s license-exempt RSS standard(s). Operation is subject to the following two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
he buys a new electrical or electronic equipment. The mains plug is used as the disconnect device, The socket-outlet shall be installed near the equipment and shall be easily accessible. Warning To avoid replacement of a battery with an incorrect type Don't disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery. Don't leaving a battery in an extremely high temperature surrounding environment To avoid battery subjected to extremely low air pressure.