D180 mPOS PAX TECHNOLOGY LIMITED
1. Contents Checklist Please check the components after unpacking. If any one of them is missing, or if there is a page missing from the product manual,ect., please contact the dealer. Name Qty. D180 mPOS 1 USB Cable 1 Product Manual 1 2.Product Description Figure 1. Front view 1. Charging LED indicator 2. Magnetic stripe card reader 3. Contactless card LED indicator 4. Display 5. Smart card reader 6.
Figure 2. Back view 7. Nameplate 8. Serial number 9. MicroUSB 3.Quick Start Connect to PC with USB cable 1) 2) 3) 4) 5) 6) Connect PC with D180 by USB cable. Shopping and click PAY button on PC. Confirm amount displayed on D180 screen. Prompt for reading card on D180. Input PIN through pinpad of D180. Finish the transaction. Connect mobile equipment through Bluetooth 1) Turn on Bluetooth of the mobile equipment and scan for D180.
3) 4) 5) 6) 7) Shopping on mobile equipment and place an order, submit order and click PAY button. Confirm amount displayed on D180 screen. Prompt for reading card on D180. Input PIN through pinpad of D180. Finish the transaction. 4.Instructions Switch the device on / off Switch on: press and hold the Cancel key until the display is on. Switch off: press and hold the Cancel key until the display goes off. Swiping magnetic stripe card Figure 3.
Reading smart card Figure 4. Insert smart card When inserting smart card into its slot, the chip of smart card must be faced up. In order to avoid any physical damage to the card or the smart card slot of the terminal, it is recommended to insert the card gently. If smart card is successfully detected by the terminal, the icon of the smart card will be shown on the top of screen. ICC Operation Process Before inserting the IC card, please check inside and around the IC card slot.
Charging LED indicator The charging LED indicator shows, Solid red when the battery is being charged. Solid green when the USB cable is connected and the battery is fully charged. 5.Installation and Usage Tips 1) Do not damage the USB cable. If the USB cable is damaged, please do not use it any more. 2) Before connecting the USB cable to a power supply such as a power adapter, please make sure that its supply voltage is appropriate for the terminal.
FCC RF Exposure Information (SAR) This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States. During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage near the body.
ISED Radiation Exposure Statement This EUT is in compliance with SAR for general population/uncontrolled exposure limits in ISED RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528 and IEC 62209. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.