Specifications

ManualsBrandsPAX ManualsElectronicsSecure Card Reader

D135 Secure Card Reader

1. Instructions

1) Power ON/OFF

Power on: Press button for 3 seconds until ‘Di’ is heard, and then power indicator light is

lighted.

Power off: Press button for 3 seconds until four status indicator light is lighted and then off,

then the POS terminal is being turned off.

2) IC Card

Put IC card chip side upward, push-in IC card slot and to bottom.

3) Contactless Card

The card read area is above the EMV Contactless symbol.

4) Battery Charge display

Connecting USB port with external adapter can charge the battery. If the power indicator

light is flashing red slowly, it indicates that pos is charging. If the power indicator is steady

green, it indicates that pos is full charge.

2.Terminal Specifications

Processor Cortex M3, 96MHz

Memory Space 1MB in-chip Flash and 4MB Out-of-chip Flash,128KB SRAM

Keyboard one ON/OFF/Download key.

IC Card Reader Conform to ISO7816, EMV L1&L2 and PBOC3.0 standard

Magnetic card Conform to ISO7811, ISO7812 standard

Contactless Card Conform to ISO14443 TypeA & TypeB;Mifare ® standard

Communication Mode BT

Interface 1 Type-C USB (Device)

Audio Buzzer

Power supply 5V/500mA

Working Condition Working temperature: 0℃~50℃

Summary of content (4 pages)

PAGE 1
D135 Secure Card Reader 1. Instructions 1) 2) 3) 4) Power ON/OFF Power on: Press button for 3 seconds until ‘Di’ is heard, and then power indicator light is lighted. Power off: Press button for 3 seconds until four status indicator light is lighted and then off, then the POS terminal is being turned off. IC Card Put IC card chip side upward, push-in IC card slot and to bottom. Contactless Card The card read area is above the EMV Contactless symbol.
PAGE 2
Relative humidity: 10%~93% (Non-condensing) Storage Condition Storage temperature: -20℃~70℃ Relative humidity: 10%~93% (Non-condensing) 3. Installation and Usage Tips 1）Avoid putting the terminal in direct sunlight, high temperature, moist, or dusty environment. 2）Forbid non-professional to repair the terminal. 3）Before insert the card, please check internal and around of IC card slot. if you found some suspicious objects , must report to related administrator. 4.
PAGE 3
FCC RF Exposure Information (SAR) This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States. During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage near the body.
PAGE 4
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en IC: 11689A-D135 ISED Radiation Exposure Statement This EUT is in compliance with SAR for general population/uncontrolled exposure limits in ISED RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528 and IEC 62209.