Aries Family QUICK SETUP GUIDE Note: Product images shown may be different than actual product received PAX TECHNOLOGY INC.
Aries Tablet Power Button Volume Privacy Shield Reader 8 Con tactless Area Ls Bee Scanner IC Card/Magnetic Swipe Card Slot
Install and Remove SIM and SAM Cards . SIMPSONS Card Slot SIM Card&Micro SD Card Slots SIMPSONS Cards SIM and Micro SD Cards Install Use ejector tool to open tray. Position SIM Card and Miro SD card on tray. Gently ® Install Open cover. Insert card with Chip push tray back into slot until firmly seated. facing Up. Close WHIPSAW card slot Remove Push SIMPSONS card further into slot. (The card will then stick out of the slot a Use ejector tool to open tray, take ° little.) Next push card again to remove it.
Privacy Shield Options Caution: If the privacy shield is not installed, you must use PC-approved alternative methods to secure the tablet keypad. Low Privacy Shield J | / High Privacy Shield Le Install High Privacy Shield Install Low Privacy Shield » Snap the higher rubber privacy shield onto the lower one. » Align the four pegs on privacy shield with the * Align the four pegs on privacy shield with the four holes around the tablet keypad. four holes around the tablet keypad.
Payment Options Hold con tactless card or device over center of con tactless logo area to trigger payment.
General Introduction ARBOR is a combination of Aries tablet and handle. It is designed for use cases like mobile in-store applications and inventory management.
Install and Remove ARE-Handle Install ARMS Step: Place tablet with the underside and handle facing up. Align the 6 orienting pegs on the handle —=2 with the holes on tablet. “Make sure switch is off on the handle. hi Step: Lower handle into the adapter. || Step: Push handle in direction shown to the end, then | slide switch to the left to lock handle in place. Remove ARMS Step: Push switch to the right to unlock handle, push up handle to the end in direction shown and remove it.
General Introduction ASS is a combination of Aries tablet and stand. Based on an ergonomic design, it supports 1809 of rotation and a 30° angle adjustment, as well as convenient cable routing and mounting options. A fastening screw locks the terminal to the stand, helping protect against unauthorized removal or tampering of the terminal. By replacing the top plate, the stand is suitable for various kinds of POS terminals. Communication Box ARE-Stand y Stylus Pen \ Cash Power © WN _ LAN raged RS232 i Use PUS