Users Manual

This document is provided to you for informational purposes
only. All features and specifications are subject to change
without notice. PAX’s name and PAX’s logo are registered
trademarks of PAX Technology Inc. All rights reserved.
PAX Technology Inc.
8880 Freedom Crossing Trail,
rd
Building 400, 3 Floor, Suite 300
Jacksonville, FL 32256, USA
7RQ\)HUQDQGH]
WRQ\IHUQDQGH]#SD[XV

P/N:200312000000429
PAX TECHNOLOGY INC.
Aries6 Smart Tablet
PAX TECHNOLOGY INC.
Note: Product images shown may be different than actual
product received.
Quick Setup Guide
PAX TECHNOLOGY INC.
Box Contents
Box Contents
• 1 – Aries6 Smart Tablet
• 1 – Power adapter
• 1 – USB cable
• 1 – SIM card ejector tool
• 1 – Privacy shield set
• 1 – Battery
• 1 – Quick Start Guide
Product Description
Product Description
Power adapter
USB cable
SIM card ejector tool
Front View
Left Side View
Right Side View
Bottom View
Top View
Underside View
Privacy shield set
Display
Keypad
1D/2D Code Scanner
Privacy Shield
Mounting Slots
(Contactless Area 1)
Charging indicator
Light
Sensor
Fingerprint Reader
Hybrid Card Reader
Power
Button
Volume+
Volume-
Camera
PSAM Card Slot
SIM+SD Card Slot
Volume+/-
USB Type C Port Cover
Audio Port
Hybrid Card Slot1D/2D Code scanner
Power Button
Battery Cover
Base Connection
Pogo Pin
Speaker
Contactless Area 2
Micro SD Card Holder
SIM Card Holder
Ejector Hole
PSAM Card
SIM Card
Micro SD Card
Card Slot View
PAX TECHNOLOGY INC.
1. To insert SAM card, open SAM card slot and insert card with
chip facing up (see page 4). Close SAM card slot cover.
2. To remove SAM card, first push it further into slot. (The card will
then stick out of the slot a little.) Next push card again to remove
it.
SAM Card
SAM Card
5
SIM/Micro SD Card
SIM/Micro SD Card
6
1. Open tray cover and insert SIM card ejector tool into hole at side
of card tray until tray opens.
2. Take tray out and put the SIM/Micro SD card on the tray in the
direction shown on page 4.
3. Gently push tray back into slot until firmly seated.
Power on: Press and hold the power button for three seconds
until screen display lights up and tablet powers up.
See page 2 (Front View) for the location of the power button.
Power off: Press and hold the power button for three seconds.
Select “Power off”.
Charge: Plug USB cable into USB port (see page 2, Right Side
View for the location of the USB port) or place the tablet onto its
base to charge the tablet.
Charging indicator: Charging indicator light displays charging
status:
• Red indicator – Tablet is charging.
• Green indicator – Charging is complete.
• Red and green indicators flashing alternately – Charging problem.
(See page 2 Front View for the location of the Charging indicator.)
Power
Power
Card Readers
Card Readers
4
Magnetic stripe card: Insert magnetic stripe card into card slot
and push to the end with magnetic stripe facing down, then pull out
card at a constant speed to swipe card.
Smart card: Insert card with IC chip facing up, then push it to the
end of the card slot. Leave card inserted until prompted to remove.
Contactless card: When prompted, hold contactless card over
center of contactless area.