S900 Mobile Payment Terminal PAX TECHNOLOGY LIMITED
1.
2. Installation 1) SAM Card Installation ① Open up battery cover, which is at the bottom of the terminal; ② Take out battery; ③ Insert SAM card to corresponding SAM card slot. 2) SIM Card Installation ① Open up battery cover, which is at the bottom of the terminal ② Take out battery; ③ Insert SIM card to corresponding SIM card slot. 3) SD Card Installation ① Open up battery cover, which is at the bottom of the terminal; ② Take out battery; ③ Insert SD card to corresponding SD card slot.
Display:3.
6) If the terminal is defective, please contact professional POS repair technicians. 7) When installing paper roll, please be aware of the cutter within paper bracket. 8) Please use standard thermal paper, in order to protect the printer and avoid paper jam. 9) Do not assemble the terminal in explosion hazardous area. 6.
radio frequency (RF) energy set by the Federal Communications Commission of the United States. During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage near the body. Although the SAR is determined at the highest certified power level, the actual SAR level of the while operating can be well below the maximum value.
IC Radiation Exposure Statement This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528 and IEC 62209. This device and its antenna(s) must not be co-located oroperating in conjunction with any other antenna or transmitter.