a AX Installation Manual $80 Handover Counter top Payment Terminal PAX TECHNOLOGY LIMITED reserves the right to change product technology specifications without notifying. a. PAX PAX TECHNOLOGY LIMITED Room 2416, 24/F., Sun Hung Kai Center, 30 Barbour Road, Hawaiian, Hong Kong Tel: +852-2588 8808 Fax: +852-2802 3300 E-mail: panicked comb Website: www.pax. com.
Cox PAX TECHNOLOGY LIMITED Appearance Description LENIN LINE Pena 152334 PIN PAD Figure 4: Ports at Bottom Installation 1) Place $80 on table 2) Connect the attached cable a) Remove port lid on bottom of SB0 b) Connect each plug of the attached cables Into the corresponding sockets on the rear panel of the terminal. ©} Put the lid on. The figure below shows completed cable installation.
Cox PAX TECHNOLOGY LIMITED 3) Insert th telephones cord supplied with the terminal Into standard JR-11 type outing which on the S80 adapter. Connect the other end of the telephone cord Into a standard JR-11 type modular telephone line loutish. 4) Connect serial facility to RS232 socket. LINE Power PIN PAD 5) Connect AC plug of power adapter info AC socket.
Cox PAX TECHNOLOGY LIMITED Keypad: 10 alphanumeric keys, 8 functional Keys, 4 ATM keys, 1 switch(ON) key Magnetic Card Reader: 1SO7812, Track 12/3, bi-directional sweeps IC Card Reader: 1, EMV2000 SAM Slots : 3, 1807818 Modem: Sync LSD, baud rate: 1200/2400/8600bps Assn V.92. up to 56Kbps) Peripheral Ports : 1RS232,1 PIN Pad, 1 Lina port, 1 USB port Printer : Thermal printer, Speed: 20 lines/sec Paper width: 58mm Paper roll outer diameter 50mm Rawer Supply: Input: 100 240VAC 50HZ/60Hz 1.0A, Output: 8.
Cox PAX TECHNOLOGY LIMITED Announcement The following techniques can be employed to provide for effective screening of the PIN-entry during the PIN entry process, Tess methods would typically be used in combination, though in some cases a method might bs used singly. Positioning of stamina on the check-stand In such way as to make visual observation of the PIN-sentry process Infeasible. Examples Include: = Visual shields designed Into the check-stand.
Coax PAX TECHNOLOGY LIMITED premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTS. A compliant telephone cord and modular plug is provided with this product, It is designed to be connected to a compatible modular jack that is also compliant. Sea installation instructions for details. The REN Is used fo determine the number of devices that may be connected fo a telephone line.
Coax PAX TECHNOLOGY LIMITED § 15.19 La belling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user.