User's Manual

PINPAD Instruction Manual

(SP20，SP30，S200，S300)

1.Instructions

PINPAD connect to POS or ECR by a communication line for entering password during

transaction process. In order to correct using, you should refer to following instructions.

1）Magnetic Stripe Card

Put magnetic stripe side of magnetic card towards device interior, swipe the card with a steady

speed during through magnetic reader slot. (Support bi-directional swiping)

2）IC Card

Put IC card chip side upward, push-in IC card slot and to bottom.

3）Tap contactless card (optional).

Put the contactless card into the sensing area above the LCD

4）SAM Card

① Remove the SAM card cover (At the bottom of the terminal).

② Insert the SAM card to the corresponding card slot.

2. Installation and Usage Tips

1）Avoid putting the terminal in direct sunlight, high temperature, moist, or dusty environment.

2）Forbid non-professional to repair the terminal.

3）Before insert the card, please check internal and around of IC card slot . when you found some

suspicious objects , must report to related administrator.

3. Password Entering Tips:

It is highly recommended to enter password as following ways:

1）Set up peep shields. Enter password with shield by the structures of cashier desk;

2）Place the POS terminal at an appropriate angle and make sure it is difficult to peer the password.

For example, the POS was installed above the movable bracket.

3）In enter password perspective, avoid surrounding video surveillance;

4）Paste text instructions to remind the customers to shelter with body or palm when enter

password.

5）Merchants can also choose other ways to protect the customer input password.

FCC Regulations:

This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

This mobile phone has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiated radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

PAGE 1
PINPAD Instruction Manual (SP20，SP30，S200，S300) 1.Instructions PINPAD connect to POS or ECR by a communication line for entering password during transaction process. In order to correct using, you should refer to following instructions. 1）Magnetic Stripe Card Put magnetic stripe side of magnetic card towards device interior, swipe the card with a steady speed during through magnetic reader slot. (Support bi-directional swiping) 2）IC Card Put IC card chip side upward, push-in IC card slot and to bottom.
PAGE 2
measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. FCC Note: Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.