D200 Wireless POS Terminal PAX TECHNOLOGY LIMITED
1. Production Description: LCD Disp la y Ma g n e t ic St r ip Ca r d So lt RF An t e n n a Ar e a Rs 2 3 2 Co n n c e t USB Co n n e ct Ca p a c it ive Ke y Ar e a Ba t t e r y Co ve r Ic Ca r d Slo t Front View Back View Scre w Ma gne tic St rip Car d Solt Bar cod e La be l Nam ep lat e Lab el Bat t er y Ar ea SAM / SIM Ca r d Slot Ant en n a Back Layout 2.
‘Di’ is heard, and then PAX LOGO will display on LCD. Power off: Press being turned off. button for 3 seconds until Shutting down... can be seen. POS terminal is 2) Magnetic Stripe Card When user swipes magnetic stripe card along the slot, the backside of card, which contains magnetic strip information, should be facing to the terminal. Bi-directional swiping is supported. It is recommended to swipe starting from left to right (or from right to left) with a constant moving speed.
Please refer to the picture below, the card read area is above the LCD. 4. Specifications Default CPU: 32-bit,MIPS Memory:32MB SDRAM, 32MB NOR Flash Display:2.
damage to the terminal. 6)If the terminal is defective, please contact professional POS repair technicians. 7)When D200 power supplied by the USB port of PC,we don’t recommend the use of CTLS function. 8)When charged by the USB port of PC, charge time will be longer, we recommend charging using the adapter. 9)When D200 is in charging, if you can't turn on the device, and you just hear "Di Di", please charge it for longer, and try again later. 6.
Cet appareil est conforme aux dispositions de la partie 15 des règles de la FCC et des normes CNR d'Industrie Canada sur les appareils radio exempts de licence. Son utilisation est assujettie aux deux conditions suivantes : (1) Cet appareil ne doit pas causer d'interférence nuisible; et (2) cet appareil doit accepter toute interférence reçue, y compris l'interférence qui pourrait causer un fonctionnement non désiré.
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: V5PD200WB. For this device, the highest reported SAR value for near the body is 0.99 W/kg.
Cet appareil est conforme aux limites d'exposition DAS incontrôlée pour la population générale de la norme CNR-102 d'Industrie Canada et a ététestéen conformitéavec les méthodes de mesure et procédures spécifiées dans IEEE 1528 et IEC 62209. Cet appareil doit être installéet utiliséavec une distance minimale de 0 cm entre l’émetteur et votre corps. Cet appareil et sa ou ses antennes ne doivent pas être co-localisés ou fonctionner en conjonction avec tout autre antenne ou transmetteur.