D200 Wireless POS Terminal 1.
Bottom View Side Socket View SAM Slot Area
2. Installation 1) SAM Card Installation ① Open up battery cover, which is at the bottom of the terminal; ② Take out battery; ③ Insert SAM card to corresponding SAM card slot. 2) Battery Installation ① Hold the battery with its facing up; ② Attach battery forelock to battery bayonet; ③ Press down the other side of the battery 3. Instruction 1) Power ON/OFF Power on: Insert power adapter or insert the battery, Press button for 3 seconds until LED backlight is on.
R.H.:10%~93%(non-condense) Storage Environment: Temperature:-20℃ ~ 70℃ (-4℉~158℉) R.H.:5% ~95%(non-condense) Dimensions:120mm 72mm 22.1mm(L W H) Weight:165g 5. Installation and Usage Tips 1)Do not damage electric wire and power adapter. If electric wire or power adapter is damaged , please do not use the terminal any more. 2) Before power adapter is plugged into power socket, please make sure that voltage which the power socket supplies is appropriate working voltage for the terminal.
7. FCC Regulations: This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: V5PD200W. For this device, the highest reported SAR value for usage near the body is 0.01 W/kg.