User's Guide

ManualsBrandsPaww ManualsElectronicsBluetooth Receiver

User Guide

Name:Bluetooth Receiver

Paww, LLC

Congratulations on your purchase of the Paww WaveCast RX Bluetooth wireless receiver! WaveCast RX

transforms any home audio system into a Bluetooth-enabled system which can wireless stream audio

from any Bluetooth-enabled source device, such as your smartphone, tablet, laptop, etc. Now you can

stream music through your favorite audio system, without being tethered by wires!

1. Product overview

① Multi-function button (MFB) – (Power on / Pairing Mode / Play / Pause / Power off)

② LED indicator

③ 3.5 mm audio jack

④ USB Type-C charging Port

Summary of content (7 pages)

PAGE 1
User Guide Name:Bluetooth Receiver Paww, LLC Congratulations on your purchase of the Paww WaveCast RX Bluetooth wireless receiver! WaveCast RX transforms any home audio system into a Bluetooth-enabled system which can wireless stream audio from any Bluetooth-enabled source device, such as your smartphone, tablet, laptop, etc. Now you can stream music through your favorite audio system, without being tethered by wires! 1.
PAGE 2
. Package Contents: A. 1 Amp USB Power Adapter (UL certificated) B. Aux 3.5mm audio cable C. USB Type-C charging cable D. User Guide 2.
PAGE 3
Please use the diagrams above as reference for the steps below: 1. Connect the included 3.5mm auxiliary cable to the the 3.5mm port on WaveCast RX (reference 3 of Product Overview). 2. Connect the other end of the 3.5mm auxiliary cable to the audio device’s 3.5mm AUX IN port (please ensure that you connect to the Aux In port and not the output port marked with a headphone). Turn on your speaker and set the input source to AUX. 3. Insert the attached power adapter to wall socket. 4.
PAGE 4
1. Press and hold the Multifunction button for 5-seconds to switch WaveCast RX off. Your audio system will prompt “power off”. 2. Remove the USB Type-C cable from the WaveCast RX to power the unit off. 4. PAIRING WITH TWO DEVICES 1. Pair the first device to WaveCast RX using the steps outlined above. 2. Switch off Bluetooth on the first device. This will place the WaveCast RX back into pairing mode. 3. Pair the second device to WaveCast RX using the steps outlined above. 4.
PAGE 5
6. FUNCTION DESCRIPTION Function Operation LED Power On Charge the WaveCast RX via USB Type-C cable Blue LED Flashes Rapidly Unplug the USB Type-C cable from WaveCast Power Off N/A RX Press and hold the Multifunction button for 3 seconds. The device stays in pairing mode for Pairing Blue LED flashes Rapidly 10 minutes. If not paired during that time, device shuts off. If music is paused, press the Multifunction Blue LED flashes twice button once to start playing the music.
PAGE 6
Note: Please make sure that the WaveCast RX is connected to an audio device prior to doing the factory reset. To do a factory reset, press the Multifunction button for approximately six seconds, or until you hear the prompt “power off” followed by two beeps. 8. PRODUCT SPECIFICATIONS • Bluetooth Version: V5.0+EDR • Chipset: QCC3003 • Operating Range: Class 2 - Up to 10 meters • Supported Profiles: A2DP v1.3, AVRCP v1.
PAGE 7
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.