Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingAmmon Black 1-Light Track Lighting Pendant

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-887-6326

Monday – Friday 9:00 a.m. – 5:00 p.m. CST

Sku Number: 349-0523

DUAL MOUNT PENDANT

Model Number: P231

PACKAGE CONTENTS

Page 1 of 5

Bolt Nut

Vintage Bulb Max.60W

Mounting Unit

Mounting Screw

Wire Nut

HARDWARE CONTENTS Note: Hardware not shown actual size.

Strain Relief

Summary of content (5 pages)

PAGE 1
Sku Number: 349-0523 DUAL MOUNT PENDANT Model Number: P231 Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-887-6326 Monday – Friday 9:00 a.m. – 5:00 p.m. CST PACKAGE CONTENTS A B C HARDWARE CONTENTS Note: Hardware not shown actual size. AA Mounting Unit X1 CC Wire Nut X3 BB Mounting Screw X2 DD Bolt Nut X2 FF EE Strain Relief X1 Vintage Bulb Max.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING ● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). ● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
ASSEMBLY INSTRUCTIONS FOR TRACK MOUNTING (continued) To Shorten the Cable of the Pendant (If in doubt, consult a qualified electrician) 1. Remove the adapter cover from the adapter holder by loosening the set screws. Remove the slide pad and spring, and set them aside. 1 Set Screw Adapter Cover Slide Pad Spring Adapter Holder 2. Unscrew the wire nuts and separate the wires. 2 Adapter Cover c.) Leave 2-3/4" of cable above 3c strain relief and then cut off the 3/8" excess cable.
PAGE 4
ASSEMBLY INSTRUCTIONS FOR CEILING MOUNTING Turn off the power at fuse or circuit box. 1. Attach mounting unit(AA) to the outlet box using two mounting screws(BB). Adjust the length of long screws on the mounting unit(AA) if necessary. 2. Cut off the cable near the bottom of the adapter(A). 1 EE Hex Nut AA Long Screw BB Cable 2 A Follow step 1 as For TRACK MOUNTING. 3. Thread the cable through the canopy and two holes of the strain relief(EE). 5.
PAGE 5
CARE AND MAINTENANCE ● To clean, turn off and wipe with a damp, non-abrasive cloth. TROUBLESHOOTING 1) The light does not come on at all: a) Make sure the wall switch and circuit breaker are on. b) Make sure the wiring is correct. 2) Fuse blows or circuit trips when light is turned on. a) Check for crossed wires, ensure wiring is correct. If unable to fix any of the above issues, please consult a certified electrician.