USER GUIDE RFID LOCKER LOCK (model : BLE100) Version 1.
Table of Contents 1. BLE Module Spec .......................................................................................................... 3 1.1 Overview .......................................................................................................... 3 1.2 Composition ..................................................................................................... 3 1.3 Specification ....................................................................................................
1. BLE Module Spec 1.1 - Overview This module performs the function of connecting the locks by Passtech with BLE 4.1 or its more recent versions. 1.2 Composition Version 1.
1.3 Specification - Operating Frequency : 2.4~2.4835Ghz -93dBm sensitivity in Bluetooth® low energy mode : BLE 4.1 250 kbps, 1 Mbps, 2 Mbps supported data rates TX Power -20 to +4 dBm in 4 dB steps RSSI (1 dB resolution) - ARM® Cortex™-M0 32 bit processor - 256 kB embedded flash program memory - 16 kB RAM - Serial Wire Debug (SWD) - Operation Voltage DC 3.3V - UART 38400bps Interface - Wake up I/O 2EA 1.
BLE Phone use - 2) Packet Format STX LEN CMD DATA ETX BCC 0x02(1) DATALEN(1) CMD(1) DATA(LEN) 0x03(1) 0xHH(1) STX (1) : 0x02 LEN (1) : 0x00~0xFF CMD (1) : Command Code DATA (LEN) : Data ETX (1) : 0x03 BCC (1) : STX ~ ETX 까지 ^ (Exclusive OR) Value 3) IC Control Command - ADVERTISING START CMD (1) : I DATA (6) TEXT CMD (1) TERMINAL ID(5) NORMAL MODE : TERMINAL ID = LOCKER ID REGISTER MODE : TERMINAL ID = "REGIS" Version 1.
- BLE CHIP POWER ON/OFF CMD (1) : P DATA (2) TEXT CMD (1) STATE (1) STATE (1) - ON "1" OFF "2" - BLE SETTING CMD CMD (1) : S DATA (3) TEXT CMD (1) 종류 (1) STATE (1) 종류 : A STATE (1) - T (stop) 4) Card Data Command - CARD REGISTER REQUEST CMD (1) : R - CARD DATA RESPONSE CMD (1) : o Version 1.
- CARD REGISTER RESPONSE CMD (1) : r DATA (17) TEXT CMD (1) - 폰 시리얼(16) CARD DATA REQUEST CMD (1) : O DATA (15) TEXT CMD (1) 0x20 (14) DATA (15) TEXT CMD (1) Version 1.
FCC compliance Information FCC Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1)The transmitter module may not be co-located with any other transmitter or antenna, 2)OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change. As long as 2 conditions above are met, further transmitter test will not be required.