MODEL : LK-P35B MOBILE PRINTER All specifications are subject to change without notice
This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication.
1. Product Overview Table of Contents 2 1. Product Overview 3 2. Unpacking 4 3. Setting up the Product 5 3-1. Installing Battery 5 3-2. Battery Charging 6 3-3. Loading the Media 7 3-4. Black Mark 8 3-5. Printer Case Usage 9 3-6. Control Panel 10 3-7. Self Test 11 4. Peripherals Connection 12 4-1. Bluetooth Connection 12 4-2. Interface Cable Connection 13 5.
3. Setting up the Product 2. Unpacking 3-1. Installing Battery PRINTER BATTERY SERIAL CABLE RECHARGER 1. Align the battery hook as shown in the picture. 2. Push the battery into the printer until it locks in place. Notes As the battery is not charged at the time of your purchase, charge the battery prior to using the printer.
3-2. Battery Charging 3-3. Loading the Media Place the paper roll as shown in the picture. Press the cover open button. (Make sure the paper is placed in right direction.) 1 2 3 4 1. The battery can be charged only when the temperature is 0~ 40°C. 2. Be sure that the printer is turn off and the battery to be charged is installed. 3. Connect the charger to the printer. 4. Recharging will now be started. Notes 1. Do not turn on the printer power while you are charging the battery. 2.
3-4. Black Mark 3-5. Printer Case Usage Put the printer into the case following the Open the Velcro. 1 2 3 4 direction as shown in the picture. Notes Black mark should be located on the opposite side of the printed side of the media. Close the Velcro. Fix this case to the belt with using the belt buckle.
3-6. Control Panel 3-7. Self Test You can check the printer setting state by doing self test when you set the printer first time or encounter some problems. - Control Circuit, Mechanisms, Print Quality, Rom version. Button Name Power button function This button is used to turn the printer on and off. When the printer is off, press this button for approximately 2 seconds and it will turn on the power. When you press this button in a state that the printer is on, the printer will turn off.
4. Peripherals Connection This product can communicate with other devices via Bluetooth communication and cable. 4-2. Interface Cable Connection 4-1. Bluetooth Connection Serial 1. The printer can be connected to devices equipped with Bluetooth communication capacity (PDA, PC, etc.). 2. Use the Bluetooth connection function supported by the device to connect to the printer. 12 Classi fications Description Bluetooth Spec. Bluetooth V2.0 / Class2(10m) Frequency 2.
5. Printer Specification Printing Method Direct Thermal Printing Speed 60mm/sec Resolution 203 DPI X 203 DPI Weight Character Size Font A (12X24), Font B (9X24) Temperature Character per Line Font A : 48pt , Font B : 64pt Character Set ALPHA NUMERIC Caractor, Extension Caractor Barcode EAN-8, EAN-13, Code39, ITF, UPC-A, Codabar, Code93, Code128, PDF417(2D) Emulation ESC/POS Driver Window CE 4.2&5.0, Window Mobile 5.
SEWOO TECH CO.,LTD. ADDRESS Doosung Bd, 689-20, Kumjung-dong, Kunpo-si, Kyunggi-do, Korea TEL 82-31-459-8200 FAX 82-31-459-8880 URL http://www.miniprinter.com Rev. 1.