Wifi kit Neops base terminals Operation manual MKL 05/018
Original edition in French (ref. MKL 05/019) Translated into English in February 2006. Copyright 2006 Parkeon. All rights reserved. Parkeon reserves all proprietary rights relating to the contents of this document. Parkeon reserves all rights over usage, reproduction, representation, marketing, translation, adaptation or modification, and generally all rights over present and future utilisation by any means, for any purpose and in any territory, throughout the period of protection.
Contents 1. ABOUT THIS DOCUMENT… ...................................................................................... 4 2. CHARACTERISTICS ..................................................................................................... 5 2.1 2.2 2.3 MAIN BOARD ............................................................................................................... 5 SLAVE BOARD .............................................................................................................
1. About this document… This document describes the operation of the Wifi kit: • Starting up, • operation, • maintenance, used to centralise Neops base terminals in Wifi. Reference ocument describing the configurations of centralised systems User manual of Parkfolio On-Line MKL 04/020 Neo Document ref. 141596 FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
2. Characteristics 2.
2.2 Slave board D5336 D5335 The slave board is connected directly to the main board centralisation connector.
2.3 Description of functions 2.3.1 Installation and initialisation The slave board and modem are mounted on the main board. Make sure the antenna is properly. Function 80: modem initialisation. To initialise the modem, use on-site programming function 80 described below: 1. MODEM PRESENT YES: 1 NO: 2 Enter 1 to start initialising the modem. Modem initialisation: From that point on, the main board initialises the modem without any more user input.
4. NETWORK REGISTRATION During this stage, the main board waits for the modem to register on the Wifi network. 1. If initialisation fails during this stage (message “Init. not completed”), that means that the modem cannot be registered on the Wifi network : check that the antenna is correctly connected to the modem and that the antenna cable is correctly screwed to the antenna adapter. 5.
Programming Parkfolio Neo On-Line numbers (function 44) This function is used to save the Parkfolio Neo On-Line numbers in the memory of the main board. Numbers 1 to 10 are the server's IP address for Wifi. 2.3.2 Wifi communication To make a Wifi call, just use function 44 to programme the IP address of the Parkfolio Neo On-Line. In order to make a GPRS call, the terminal needs to know the server’s UDP Port number : this is the number of the port used to communicate with Parkfolio Neo OnLine.
Below is a flowchart showing what action should be taken if there is a problem with function 40 during Wifi configuration: Function 40 Communication OK Transmission problem WIFI Centralisation system OK Check the UDP port number in GPRS Setup of the Parkfolio Neo On-Line for this SIM Check the firewall and router setup.