User's Manual

ManualsBrandsPanyu Elite Century Electronics ManualsComputers & AccessoriesWireless Keyboard

User Guide

Wireless Keyboard

Please read this manual carefully before using the keyboard.

System available

Compatible with IBM PC and Windows

keys,

Microsoft®Windows®95/98/2000/NT/XP.

INSTALLATION

Shut down and turn off the computer.

Pull out the primary keyboard.

Plug the round PS2 or USB connector into the computer’s

round PS2 or USB port. (Refer to picture 1-1)

Battery Installing:

1) Overturn the keyboard and take down the cover of the

keyboard battery compartment.(Refer to picture 1-2)

2) Insert two “AA” 1.5V batteries correctly into the keyboard

battery compartment. (Refer to picture 1-3)

Channel Setting

1) Turn on the computer.

2) Gently press the key “connect” on the top of receiver after

the windows operation system is fully running. (Refer to 1-4)

Summary of content (4 pages)

PAGE 1
User Guide Wireless Keyboard Please read this manual carefully before using the keyboard. System available Compatible with IBM PC Microsoft®Windows®95/98/2000/NT/XP. and Windows TM keys, INSTALLATION Shut down and turn off the computer. Pull out the primary keyboard. Plug the round PS2 or USB connector into the computer’s round PS2 or USB port. (Refer to picture 1-1) Battery Installing: 1) Overturn the keyboard and take down the cover of the keyboard battery compartment.
PAGE 2
3) Press the key “connect” on the right of keyboard and then test the connection by pressing freely one key of the keyboard . If it works properly, the lights on the receiver with flash indicating a strong signal. (Refer to 1-5) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
instruction) 2. Keyboard can not work after installing completely. l Check the keyboard and ensure the batteries correctly plugged into the battery compartment. l Check and ensure the keyboard projector and the receiver rein the same channel. 3. If it becomes slow or even quit working. l Check and change a new battery if the old one is in the low power situation. l It will be form a barrier prohibiting smooth operation that the receiver is around high-radiancy area, check and make it far from that.
PAGE 4
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.